Parts for Ge WSM2480TBAAA: 05 - Dryer Front Panel & Door Parts

This genuine-style door gasket replaces a worn or damaged refrigerator door seal to restore a tight closure and help maintain proper cooling. It stops cold air loss and reduces frost build-up when sealing correctly. What it does:

• Seals the refrigerator door to keep cold air in and warm air out
• Helps reduce frost and moisture buildup inside the compartment
• Can improve cooling consistency and reduce energy waste when effective
• Commonly replaced for visible cracks, tears, or a flattened seal that no longer closes snugly

• Disconnect power to the appliance before starting any service
• Clean the door frame and mating surface before installing the new gasket
• Align the gasket evenly around the door and press into the channel until fully seated
• Check door alignment and hinges to ensure a proper long-term seal

This bearing seal helps protect a dryer drum or motor shaft bearing from lint, moisture and debris to keep the bearing turning smoothly and extend service life. It's a small replacement part used where a tight seal is needed around a rotating shaft. What it does:

• Seals the gap around a shaft to keep lint, dust and moisture out of the bearing area
• Helps maintain proper bearing lubrication and reduces premature wear
• Restores the intended barrier between the drum/motor shaft and the cabinet interior
• Can reduce noise or roughness caused by contaminated bearings when installed as part of a bearing service

• One bearing seal

• Disconnect power (and gas if applicable) before starting any repair
• Access may require removing panels, the drum or motor depending on model; follow manufacturer service instructions
• Inspect bearing and surrounding components and replace any worn parts to avoid repeat failure
• Use only OEM-recommended parts and avoid over-stressing the seal during installation