Parts for Lg WM3431HS: Dryer Parts

Dissolves odor-causing residue and mildew buildup in washing machine tubs. Use every 30 washes to maintain freshness. Verify fit with your model.

Dryer exhaust duct outlet that channels hot air from the cabinet to the external vent. Replace if cracked, broken, or causing air leaks around the vent.

Outlet duct housing for front-load washers. Connects drain pump to exterior outlet. Replace if cracked, broken, or leaking at connection points.

This is a DC-powered blower fan motor assembly used in the washer to circulate air for drying or ventilation purposes. It helps move air through the drum area to assist with moisture removal. Replace this motor if the washer produces unusual noises during the fan cycle, the blower fails to run, or clothes remain excessively damp after the cycle completes.

This is a DC-powered blower fan motor assembly used in the washer to circulate air for drying or ventilation purposes. It helps move air through the drum area to assist with moisture removal. Replace this motor if the washer produces unusual noises during the fan cycle, the blower fails to run, or clothes remain excessively damp after the cycle completes.

This Thermostat Assembly monitors and regulates internal temperature within the appliance's heating circuit. Replacing a failed thermostat restores proper heat control, helps prevent overheating, and can resolve common heating performance issues so cycles run correctly. What it does

• Senses internal temperature and opens/closes the heater circuit to maintain proper heat
• Provides over-temperature protection by cutting power at unsafe temperatures
• Helps ensure consistent heating performance throughout the cycle
• Helps with symptoms such as no heat, overheating/shutting off, or unusually long cycle times

• 1 thermostat assembly

• Disconnect power before servicing; allow hot components to cool
• Access the thermostat location (varies by model); note wire positions before removal
• Mount flush to the surface for accurate sensing; transfer original hardware if required
• After installation, test operation; use a multimeter for continuity checks if needed

Dissolves odor-causing residue and mildew buildup in washing machine tubs. Use every 30 washes to maintain freshness. Verify fit with your model.

This heater assembly warms the wash water inside the tub so the control can reach and maintain the selected temperature. Replacing a failed element restores proper heating performance and helps return cycle times to normal. What it does:

• Heats the water in the washer's tub during applicable cycles
• Helps the control reach and hold target temperatures for better cleaning
• Failure symptoms can include cold wash water, extended cycle times, and reduced cleaning performance
• Visual damage or an open circuit on the element indicates replacement is needed

• 1 heater assembly

• Disconnect power and turn off water before servicing
• The heater mounts at the bottom of the outer tub; remove front or rear panels as required by your model to access it
• Note wire locations; loosen the center nut, press the stud to release the old seal, and carefully withdraw the element
• Seat the new gasket evenly, tighten the nut to compress the seal, then run a test cycle to check for leaks and proper heating

Washer not heating or running cold cycles? This thermistor assembly monitors water temperature to ensure proper wash performance. Moderate difficulty repair.

Thermal fuse that protects the washer motor circuit from overheating. Interrupts power if motor temperature exceeds safe limits. Replace if washer stops mid-cycle or won't start.

Seals the temperature sensor where it passes through the washer tub. Replace if worn or leaking to prevent water damage. Confirm fit with your model.

Dissolves odor-causing residue and mildew buildup in washing machine tubs. Use every 30 washes to maintain freshness. Verify fit with your model.