Parts for Electrolux E24ID75SPS1A: Electrical Parts

Removes residue, odor-causing soils, and food particles from dishwasher tub and gasket. Use monthly to eliminate unwanted odors and maintain peak performance.

Dishwasher not filling with water or showing i20 error? The water inlet valve controls water flow into your dishwasher. DIY repair in under an hour.

Fix standing water in your dishwasher with this drain pump assembly. Resolves drainage issues and prevents water backup. Direct replacement part.

Fix a dishwasher that won't drain or fill properly with a new water pump. This part circulates water during wash cycles. Moderate difficulty repair.

Fixes dishwasher leaking, error code i20, or pump that won't stop running. Monitors water pressure to control wash cycles. DIY-friendly repair.

Replacement sensor assembly that detects appliance operating conditions and sends readings to the control system for proper operation. Installing a working sensor restores reliable feedback and helps resolve related error codes or inconsistent performance. What it does:

• Detects operating conditions and provides electrical feedback to the appliance control.
• Enables the control board to monitor and adjust cycles based on measured readings.
• Faulty or intermittent sensors can cause incorrect readings, error codes, or unstable/incorrect appliance operation.
• Replacing a failed sensor restores accurate sensing and helps return the appliance to normal function.

• Always disconnect power to the appliance before starting work to avoid shock or injury.
• Handle the sensor and wiring gently; avoid pulling on wires or bending sensor probes sharply.
• Ensure connectors are fully seated and routed clear of moving parts or heat sources.
• After installation, restore power and verify proper operation and that any previous error codes are cleared.

If your dishwasher won't start or stops mid-cycle, a faulty door lock may be the cause. This safety component secures the door during wash cycles.

Fix poor drying or excess moisture with this dishwasher blower assembly. Direct replacement for circulation issues. Moderate DIY repair, 1-2 hours.

This switch assembly restores electrical on/off control for a specific appliance function. Replace a worn or failed switch to stop intermittent operation and return reliable control to the affected circuit. What it does:

• Provides the electrical on/off or function control for the appliance circuit.
• Replaces a failed switch that can cause intermittent operation or unresponsive controls.
• Helps resolve symptoms such as a function that won't start, no response from the control, or erratic switching.
• Connects to the existing wiring harness and mates with the original mounting points.

• Disconnect power to the appliance before beginning any work.
• Remove the appropriate access panel to reach the switch; note wire and terminal locations before disconnecting.
• Unplug the wiring harness or carefully detach terminals, swap the switch assembly, then reconnect securely.
• Restore power and verify the replaced switch operates the function correctly.

Removes residue, odor-causing soils, and food particles from dishwasher tub and gasket. Use monthly to eliminate unwanted odors and maintain peak performance.

Illuminates your dishwasher interior for better visibility when loading and unloading dishes. Replace if light fails or dims due to wear or damage.

Fix dishwasher control failures or intermittent electrical issues with this multi-connector wiring harness. Restores reliable power and signal routing.

Replacement mounting screw for dishwashers. Secures interior components and panels. Order a new screw if yours is stripped, missing, or damaged.

Wire harness for dishwashers. Connects electrical components inside the unit. Replace if wires are frayed, connectors are damaged, or harness is broken.

Dishwasher won't power on or has intermittent electrical issues? The main wiring harness connects control and power circuits. Moderate DIY repair.

Removes residue, odor-causing soils, and food particles from dishwasher tub and gasket. Use monthly to eliminate unwanted odors and maintain peak performance.