Parts for Poulan 96042016600: Electrical Parts

This part is a switch in the control system of a lawn tractor or lawnmower that activates the central electrical systems. Known as a starter switch, it is responsible for turning the power on for the mower. If the engine will not start and the electric starter does not engage, the ignition switch may be defective and needs to be replaced. To check an ignition switch, use an ohmmeter to determine if there is any connection between the S and B terminals. If no connection is detected, the ignition switch is the problem. Replacing an old or malfunctioning ignition switch on a riding mower is quick and easy. First, disconnect the battery and remove the bolt connecting it to the negative cable. Remove the ignition switch and disconnect the wire harness attached to the back. Install the new ignition switch, connect the wire harness, and then reconnect the battery. This part is compatible with specific products from popular brands like Ariens, Craftsman, Husqvarna, Murray, Poulan, Ryobi, and Weed Eater. It is a genuine OEM part sourced directly from the manufacturer and is sold individually.

This headlight switch is a genuine Husqvarna part, sold individually. This headlight switch can be used as a replacement part in a lawnmower. The purpose of the headlight switch in a lawnmower is to provide the operator with a source of illumination in order to operate the appliance at any point during the night or during a period of sustained darkness.The headlight switch in a lawnmower might have to be completely replaced if it can no longer trigger the turning on of the headlights of the appliance when the operator desires to use the appliance in darkness. The headlight switch could suffer damage due to exposure to inclement weather, general wear and tear over long-term use, or an accidental collision with a hard object.This component is a genuine OEM replacement part sourced directly from the manufacturer. It is sold individually. This headlight switch is compatible with the following outdoor appliance brands: Husqvarna, Craftsman, Ariens, Poulan, Murray, and Dixon.

This wire harness is a genuine Husqvarna part, sold individually. This wire harness can be used as a replacement part in a lawn mower. The purpose of the wire harness in a lawn mower is to transmit and pass electrical currents and power throughout the entire appliance through a series of wires, cables, and terminals.The wire harness in a lawn mower might have to be completely replaced by this genuine OEM replacement part in the event that the original suffers damage that cannot be repaired. If the engine is shutting off, hard starting, or if there is corrosion on the terminals, or glitching lights, a wire harness in the mower may be damaged. This replacement is a standard process that will not take too much time and will only require basic tools to conduct.Sourced directly from the manufacturer, this component is a genuine replacement part that is sold individually. This wire harness is compatible with the following outdoor appliance brands: Husqvarna, Craftsman, and Poulan.

The starter solenoid, also called a starter relay, is a low-amperage relay that completes the high-amperage connection between the starter motor and the battery when the ignition key is turned. The starter solenoid is needed to engage the starter motor. When the ignition is turned on, the battery sends a small electrical charge to the starter solenoid. The solenoid shuts a switch, so a more significant amount of current is sent to the starter motor. The starter motor shaft starts to rotate and engage the teeth of the flywheel. The flywheel then turns the crankshaft to put the engine in motion. A bad solenoid can deny the flow of electricity to the starter motor and prevent engine startup. However, other underlying problems may also exist. The battery may be in good condition, but the engine is not cranking, or clicking and grinding noises may come from the solenoid. These are signs that the starter solenoid should be replaced. This starter solenoid is for use in riding lawn tractors and zero-turn riding mowers. It is compatible with specific models from different brands, including Ariens, Craftsman, Dixon, Husqvarna, Hyper Tough, Jonsered, Murray, Poulan Pro, Redmax, and Snapper. It is a genuine OEM replacement part sourced directly from the manufacturer and is sold individually.