Electrolux Range / Cooktop / Oven Gasket & Seal

This burner seal fits around a cooktop burner to help keep spills and debris out of the burner housing and provide a stable, centered burner location for consistent heating. It restores a flush seal between the burner and the cooktop surface. What it does:

• Forms a protective gasket around the burner to block food, grease and liquids from entering the cooktop cavity
• Cushions and centers the burner, reducing wobble and promoting even element-to-surface contact
• Helps reduce smoke or odors caused by spills burning on exposed internal surfaces
• Restores proper fit after a cracked, torn or missing seal

• One burner seal

• Disconnect power to the appliance before servicing; if the range is gas, shut off the gas supply
• Remove the burner or lift the cooktop per your model's service instructions to access the seal area
• Clean and dry the mounting surface thoroughly before installing the new seal
• Press the seal into place; do not stretch excessively or use solvents/adhesives unless your model's instructions specify

This door gasket seals the refrigerator door to help maintain proper temperature and energy efficiency by preventing warm air from entering the cabinet. It replaces a worn or torn seal to restore a tight closing perimeter. What it does:

• Creates an airtight seal around the refrigerator door to help keep cold air in and warm air out.
• Helps reduce frost buildup and keeps food at consistent temperatures.
• Commonly replaces gaskets that are cracked, flattened, torn, or no longer form a tight seal.
• Can reduce excessive compressor run time and cycling caused by air leaks.

• One refrigerator door gasket.

• High-level DIY replacement: remove the old gasket, clean the door flange, and press the new gasket into the retainer channel; some gaskets may require slight heating to set the fit.
• Check alignment and ensure gasket fully seats around the door perimeter before testing.
• Use basic hand tools; disconnect power if working near electrical components or lighting.

This door gasket is a direct-fit replacement seal for your refrigerator door that helps maintain an even internal temperature and reduces air leaks and moisture intrusion for better cooling efficiency. What it does:

• Forms a tight seal around the refrigerator door to limit warm air entry
• Helps reduce frost and moisture buildup by keeping humidity out
• Supports consistent cooling and efficient compressor cycles
• Minimizes energy loss caused by a compromised door seal

• High-level swap: remove the old gasket by loosening retaining screws/clips, seat the new gasket into the channel, and retighten hardware as needed
• Warm the gasket (hair dryer or hot water) if needed to flex and fit corners smoothly
• Inspect the door flange and magnetic strip for damage before reinstalling
• Always unplug the appliance or shut off power before performing repairs

This replacement door gasket seals the refrigerator door to help maintain proper cooling and reduce air leaks. It restores a tight seal to help prevent temperature fluctuations and excess energy use. What it does:

• Forms an airtight seal around the refrigerator door to keep cold air inside
• Helps reduce frost buildup and warm spots caused by a failing seal
• Can improve cooling consistency and reduce compressor run-time when worn gaskets are replaced
• Fits into the door channel and compresses to close gaps between the door and cabinet

• Disconnect power to the appliance before starting any work
• Clean the door channel thoroughly and remove old gasket before installing the new one
• Warm the gasket to improve flexibility for easier installation; avoid open flames or high-heat tools
• Press gasket fully into the channel and check for even compression around the entire door; trim only if the manufacturer explicitly states trimming is required

This refrigerator door gasket creates a tight seal around the door edge to help maintain proper temperature and energy efficiency. It replaces a worn or torn seal to reduce warm air leaks and improve cooling performance. What it does:

• Seals the refrigerator door to keep cold air in and warm air out
• Helps prevent frost buildup and uneven temperatures inside the compartment
• Reduces compressor run-time caused by air leaks
• Common symptom: warped, cracked, or compressed gasket that no longer seals

• One refrigerator door gasket

• Inspect door edge and mounting channel; clean before installing the new gasket
• Gasket may need to be warmed or eased into the channel for a snug fit
• If the door is misaligned or hinge issues exist, address them before gasket replacement
• Turn off power to the appliance or disconnect before doing any repairs; wear work gloves to avoid sharp edges