Parts for Briggs & Stratton 21C114-0370-E2: Exhaust System, Rewind Starter Parts

Rewind starter housing for small engines. Replaces broken, cracked, or damaged housing that covers the starter mechanism. Essential structural component.

Replace your worn, frayed, or broken recoil starter handle and rope on small engines. Restores pull-start functionality with fresh grip and cord.

Engine won't start? A worn pawl friction plate in the starter assembly prevents cranking. This small engine part transfers power to the starter cup.

Engine won't start or recoil pull cord spins freely? This ratchet pawl engages your recoil starter system. Comes as a set of two. Simple repair.

Replacement screw that secures the pawl friction plate in lawn and garden engines. Replaces lost, stripped, or damaged flange bolts on the recoil assembly.

Fix an engine that won't start or has a broken pull cord with this rewind starter assembly. Direct replacement part for small lawn and garden engines.

This is an authentic muffler deflector screw that is found in small engines for outdoor power equipment from Briggs & Stratton. This metal screw is designed to secure the muffler deflector to the flywheel. In select models, it may also be used to secure the starter clutch to the flywheel. The screw is durable but exposed to high heat and constant wear, which means that it can become damaged or worn with regular use. If the screw is lost or damaged, it will need to be replaced. It should always be replaced with a genuine OEM part. This OEM muffler deflector screw is manufactured by Briggs & Stratton to exact standards and is compatible with several models of small engines. It can be used with various models of blowers, pressure washers, generators, and snow throwers from Toro, Murray, and Briggs & Stratton. It is sold as an individual replacement part. To replace this screw, the flywheel cover will need to be removed. Then, if it is still present, the old screw will need to be removed and the new one can be installed. This screw requires a hex or Torx screwdriver to install. Always wear gloves and disconnect the spark plug for safety when performing engine repairs.

This replacement friction spring is a genuine OEM part meant for any number of small appliance engines run using a starter rope. This spring absorbs large amounts of kinetic energy that could damage the starter rope pulley system. It helps keep the pulley from being overstretched, which would create enough pressure to break the entire system. This spring sits at the center of the pulley system and creates resistance as the user yanks the starter rope. Friction springs can become worn out after repeated use, especially if a user tends to yank the starter rope quite forcefully. The most obvious sign of a worn of friction spring is if the pulley system lacks any resistance. As the user pulls the cord, they should feel a little pull back, but if the friction spring is worn, there will be much less resistance. Replacing this part is straightforward and will only require a screwdriver. Simply open the pulley system, carefully remove the old spring, and install the new one. This part is compatible with a wide number of appliances from Toro, Vanguard, Briggs & Stratton, and Lawnboy. It comes sourced from the original manufacturer and ships individually.

Pull cord won't retract or rewind on your engine? This recoil pulley and spring assembly restores proper starter function. DIY-friendly repair.

Pull cord won't retract or rewind on your engine? This recoil pulley and spring assembly restores proper starter function. DIY-friendly repair.