Parts for Kenmore 587.17259200 (58717259200, 587 17259200): Frame & Wrapper Parts

Removes residue, odor-causing soils, and food particles from dishwasher tub and gasket. Use monthly to eliminate unwanted odors and maintain peak performance.

This metal bracket secures the appliance's front frame/trim to the cabinet, keeping the front panel aligned and stable for a clean appearance and quiet operation. Replaces a worn or damaged front frame support. What it does:

• Fastens the front frame or trim to the cabinet to maintain panel alignment
• Prevents excessive movement, vibration, and rattling of the front panel
• Helps keep gaps even for proper door/trim fit and appearance
• Supports proper seating of adjacent panels and controls

• Disconnect power to the appliance before beginning any work
• Remove the front trim or access panel to reach the bracket fasteners
• Use common hand tools to remove and replace the bracket; retain original fasteners unless damaged
• Inspect surrounding trim and mounting points for damage and replace as needed; test panel alignment after installation

No.10 - 16 x 3/8

Fixes dishwasher not filling, slow filling, or continuous water flow. Controls water entering the tub. Quick 15-30 minute DIY replacement with basic tools.

Dishwasher won't fill with water? A faulty water level float switch prevents proper filling. This switch assembly typically takes 15 minutes to replace.

10 - 16 x 3/8 , hex

Threaded

Removes residue, odor-causing soils, and food particles from dishwasher tub and gasket. Use monthly to eliminate unwanted odors and maintain peak performance.

A small top-panel screw used to secure the appliance's top or trim pieces so panels stay aligned and stable. Simple replacement for loose or missing fasteners to restore proper fit and reduce rattling or shifting. What it does:

• Fastens the top panel or trim to the appliance cabinet
• Keeps panels aligned to prevent gaps and reduce vibration noise
• Replaces stripped, missing, or rusted screws that cause loose fits
• Works with the original mounting hole and thread engagement

• Turn off power to the appliance and unplug before accessing panels
• Use the correct screwdriver or driver bit to avoid stripping the head
• Replace like-for-like: match screw length and thread to ensure secure fit
• If rust or thread damage is extensive, replace mating hardware or use a new captive fastener as needed

Replaces a cracked or broken dishwasher housing assembly cap. This protective cover installs over internal components and may need replacement if damaged.

Replaces a cracked or broken dishwasher housing assembly cap. This protective cover installs over internal components and may need replacement if damaged.

A small molded clip that secures appliance wiring and harnesses to the cabinet, helping keep wires in place and reducing wear or rubbing. Use this clip when a loose or shifted harness needs a reliable anchor point. What it does:

• Fastens wiring or harnesses to the cabinet to prevent movement and chafing
• Keeps wires routed away from heat, moving parts, and sharp edges
• Helps reduce vibration noise caused by loose wiring
• Can prevent intermittent electrical issues caused by damaged insulation or connectors

• Disconnect power before accessing internal wiring or panels
• Remove the panel or trim needed to reach the original clip location
• Press the clip into the factory mounting hole or snap the wire into the clip until secure
• Inspect nearby wiring and harnesses for damage; replace any damaged wiring before reassembly

Secures wiring harness to prevent chafing and maintain safe wire routing in washers, dryers, and laundry appliances. Replace if loose or broken. Check your model for compatibility.

Replacement mounting screw for dishwasher panels and internal components. Needed when original screws are stripped, missing, or corroded during repairs.

Removes residue, odor-causing soils, and food particles from dishwasher tub and gasket. Use monthly to eliminate unwanted odors and maintain peak performance.