Parts for Kitchenaid KSRF42DTX00: 12 - Freezer Door Parts

This part has been discontinued and is no longer available.

Replace a worn or leaky seal with this refrigerator door gasket. It creates an airtight barrier between the door and cabinet to keep cold air in, reduce frost and moisture, and help your refrigerator run efficiently.

• Forms the perimeter seal so the door closes tightly against the cabinet
• Helps maintain stable temperatures and humidity, reduces frost/condensation, and limits energy loss
• Replace if the gasket is torn, cracked, deformed, or not sealing evenly
• Common symptoms: warm spots, moisture around the door, frost along the liner, or the door popping open

• Disconnect power before servicing
• Warm the new gasket in hot water or with low heat to relax shipping folds for easier fit
• If your model uses a retainer, loosen screws, remove the old gasket, press the new lip fully into the channel, then tighten evenly
• Check the seal all around and adjust hinges if needed; use a "dollar-bill test" to ensure even tension

Size: 1/4 inch hex head, 10-12 x 1/2 inch.

This screw is used to secure the handle end cap to the center of the door. The screw size measures 8-18 x 1/2 inches.

This screw is used to secure the handle end cap to the center of the door. The screw size measures 8-18 x 1/2 inches.

This screw is used to secure the handle end cap to the center of the door. The screw size measures 8-18 x 1/2 inches.

This door shelf trim is the front bar that snaps onto a refrigerator's door bin to keep bottles and containers secure. Replace a cracked or missing retainer to restore safe, organized storage on the door.

• Attaches to the door shelf/bin to hold items in place during door movement
• Restores function when the original bar is cracked, broken, warped, or missing
• Helps prevent items from sliding or falling from the door
• Common symptoms: loose or broken trim, bar won't stay attached, door shelf won't hold items properly

• Disconnect power and remove items from the affected shelf before service
• Release the old bar (squeeze tabs or slide ends free), align, and snap the new trim onto the door shelf/end caps
• Allow cold plastic to warm to room temperature to reduce risk of cracking
• Verify secure engagement before reloading the shelf

This screw anchor is a small plastic fastener that secures panels and trim on appliances, preventing screws from stripping or pulling out. It provides a reliable anchor point for screws where threaded material is thin or absent. What it does:

• Creates a secure mounting point for screws in sheet metal, plastic or thin panels
• Helps prevent screw looseness, stripping, and parts that shift or rattle
• Commonly used to hold trim, panels, or interior components in place
• Works with compatible screws to distribute load and stabilize attachments

• Use the correct screw size and length; anchors are made for specific screw diameters—do not force oversize screws
• Align anchor in the prepared hole before driving the screw to avoid cracking the anchor or surrounding material
• Hand-start screws until seated, then tighten gradually—do not overtighten to prevent stripping or damage
• Disconnect power and follow appliance safety procedures before accessing internal panels