Parts for Frigidaire FPBC2278UF3: Freezer Ice Maker Parts

Fix a refrigerator not making ice or dispensing water with a new water inlet tube. Restores proper flow from valve to ice maker and dispenser.

This complete ice maker assembly automatically produces and harvests ice cubes for your refrigerator's ice storage bin. It fills with water, freezes it into cubes, and cycles them out when the harvest cycle activates. Replace this assembly if your ice maker stops working entirely, produces poor quality ice, or leaks water into the freezer.

Factory fastener that secures panels, brackets, and internal components. Replace missing, stripped, or corroded screws to restore tight fit and eliminate rattling.

Replacement mounting screw for refrigerators, ovens, ranges, and cooktops. Secures interior panels, components, and trim. Needed when original is stripped, missing, or damaged during repair.

Ice maker not filling or leaking water? This water tube kit connects your water supply to the ice maker assembly. DIY-friendly repair for slow ice production.

Insulation panel for bottom-mount refrigerators. Replaces damaged, compressed, or missing insulation that affects temperature retention and efficiency.

No water or ice from your refrigerator? A faulty water inlet valve often causes this. Easy DIY repair with basic tools in under 30 minutes.

This is a factory-style replacement screw used to secure appliance components. It restores proper fastening where the original screw is missing, stripped, or damaged so panels and assemblies stay firmly attached. What it does:

• Fastens panels, brackets, or components to the appliance frame or assemblies
• Replaces missing or damaged mounting hardware that can cause rattles or loose parts
• Provides the correct fit and thread engagement for a secure connection
• Helps maintain appliance alignment and safe operation

• Use the matching screwdriver or bit to avoid stripping the head
• Tighten until snug; do not over-torque to prevent thread or part damage
• Turn off power and remove any access panels before working on electrical components

Secures tubes and wiring in your refrigerator. Replace if clips are broken or connections are loose. Confirm fit with your model number.

Replace a cracked or broken refrigerator mounting bracket. Secures interior components in proper alignment. Essential when original bracket is damaged or missing.

This ice container collects and stores ice produced by the freezer icemaker so you can access and organize frozen cubes. Replace a cracked, missing, or warped bin to restore normal ice storage and reduce spills in the freezer compartment. What it does:

• Collects and holds ice dispensed from the icemaker so cubes stay contained and accessible.
• Aligns under the icemaker chute to catch ice as it cycles.
• Helps prevent ice from spilling onto freezer shelves when the original bin is damaged or missing.
• Common symptom: ice falls onto the shelf, the icemaker backs up, or the bin is cracked or broken.

• Disconnect power to the refrigerator before service to avoid injury.
• Remove food and any loose ice from the freezer area before removing the old bin.
• Slide the replacement bin into the same location and ensure it seats securely under the icemaker chute; do not force.
• If ice is stuck, allow the area to thaw or carefully remove ice by hand; avoid sharp tools that can damage components.

Connects refrigerator water line to inlet or valve with secure seal. Replace if cracked, leaking, or damaged to restore proper water pathway connection.

Fixes no water from dispenser or ice maker issues. This water tube restores flow from valve to dispenser and ice maker. Stops leaks from damaged tubes.

Fix no water or ice issues with this refrigerator water tube. Restores flow from inlet valve to dispenser and ice maker when the original is cracked or leaking.

Small retainer clip that secures components, panels, tubes, or wires in place inside your refrigerator. Replace when worn, broken, or missing to restore fit.

Connects sections of water tubing inside your refrigerator. Replace this adapter if cracked, leaking, or popping off to stop drips and water damage.

Routes water from the valve to the dispenser and ice maker. Replace if cracked, kinked, or leaking to restore proper flow and prevent water damage.