Parts for Ge GFSF6PKBABB: 03 - Freezer Section Parts

Replace your refrigerator water filter every 6 months to maintain clean water and ice. Removes contaminants for fresh taste. Easy DIY install in minutes.

This defrost thermostat monitors temperature in your refrigerator's freezer section to control the defrost cycle. It signals when frost buildup requires melting and stops the defrost process when complete. Replace this part if you notice excessive frost buildup, ice blocking air vents, or inconsistent cooling.

Replaces the freezer evaporator defrost heater to melt frost and keep the evaporator fins clear during the defrost cycle, helping restore proper airflow and more consistent cooling when frost or ice builds up. What it does:

• Heats the evaporator fins during the defrost cycle to remove accumulated frost and ice.
• Common symptom: visible frost or ice buildup on evaporator coils or freezer walls.
• Other symptoms: reduced cooling performance or fluctuating/freezer temperatures that may indicate a defrost failure.
• Works as the heating element in the refrigerator's defrost system to prevent recurring frost accumulation.

What's included: One defrost heater. Install notes:

• Always disconnect power to the appliance before servicing to avoid shock or injury.
• Heater mounts near or on the freezer evaporator; access typically requires removing interior panels and the evaporator cover.
• Inspect wiring and connectors for damage; test the old heater for continuity before replacement.

Refrigerator light lens cover protects the bulb and diffuses light. Replace if cracked, yellowed, or broken to restore proper lighting. Confirm fit with your model number before ordering.

The Light Bulb (40W) is an OEM component for GE refrigerators. As an essential task lamp, it illuminates the interior of the refrigerator and freezer compartments. 

All light bulbs will eventually burn out with consistent use over many years. Vibration during compressor cycles can also potentially disrupt bulb filaments faster. 

Symptoms of a burnt out refrigerator light bulb include:

• Dim or no light illuminating inside refrigerator shelves  
• Shadows and dark spots making it difficult to find items
• Higher utility costs from leaving the door open to see inside

This bulb is also compatible with refrigerators from brands like Hotpoint, RCA, and some Kenmore models. 

Retaining spring secures the fan blade to the motor shaft in your refrigerator. Replace if spring is broken, missing, or loses tension.

This temperature sensor monitors internal refrigerator temperatures and relays them to the control, helping the unit maintain consistent cooling. Replacing a failed sensor restores accurate temperature regulation and more reliable operation. What it does:

• Measures compartment or evaporator temperature and sends a resistance signal to the control board
• Helps the control modulate compressor and fan run times for proper cooling
• Typical failure signs: sections too warm or too cold, erratic temperatures, or running longer than normal
• Causes inaccurate temperature readings compared to setpoints

• 1 temperature sensor assembly

• Disconnect power before servicing
• Access the sensor in the affected section; release any cover/clip and unplug the connector
• Route the new sensor's wiring like the original and ensure it's fully seated in its holder or clip
• Restore power and allow up to 24 hours for temperatures to stabilize