Christopher H Richmoind , ME April 22, 2017 Appliance: Frigidaire Washer Frig FAFW3001LW3 E43 error code washer was shutting off before spin cycle About a year ago, the washer was doing a similar thing, where it would shut off before the spin cycle started. The coin trap was completely clogged then, so I checked it first this time. It was clear, so I took the drain pump out and checked that as well. Nothing seemed to be physically wrong with the machine, so I put it in diagnostic mode, which gave me error code 43 when I tried the spin cycle. This one of the codes for a bad control board. Replacing the board only took about 15 minutes. The hardest part was prying the wire anchors from the old board. I had to jimmy them out with a screwdriver. The washer works great now! Read More... 7 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 2+ hours Tools: Pliers, Screwdrivers
Carolyn K Bristol , TN December 14, 2015 My washer would not turn on no power Was not for sure it was the power board but I bought from Appliance Pros cause I could return it if it did not fix my washing machine, Watched U Tube and easy install , Powered Up ! No more Laundry Mat for me . Thank you Appliance Pro , you saved me from buying a new washer or paying someone at least 200.00 to do something I could do myself Read More... 2 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers
Jesus S Sherman Oaks , CA June 09, 2018 Not spinning or draining water I change the door lock Read More... Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Pliers, Screwdrivers
Tom N Ingram , TX June 15, 2019 Appliance: Frigidaire Laundry, Washer, Front-Load FAFW3801LW5 Frigidaire FAFW3801LW5 error code E5O Main control board easy enough to replace, however it did not solve problem, which was that the motor would not run. Water would run and drain pump would drain when running diagnostic test. Motor control board was more difficult to remove due to its placement. Once installed washer functioned normally. Read More... Do-It-Yourself Rating: Repair Time Estimate: 1-2 hours Tools: Pliers, Screwdrivers
Rick M Lewisburg , TN August 20, 2015 Appliance: Model FAFW3801LW5 The control board flashing random lights and beeping would not run a cycle on any setting Ordered new control board and replaced it, the repair would not have taken as long as it did but when I unscrewed the control board from the front panel the delay start button sets in there loose and fell down in the washer so I had to take the front of washer loose to get to button under drum, other than that repair would have taken 30 min or less it was very easy. part works great and prompt shipping was nice. Read More... Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers