Joe G Corpus Christi , TX September 21, 2019 The oven control burned out. Just unscrewed upper back panel with a 1/4 inch nutdriver,Then I took off 4 screws on the oven control, unplugged the control then replaced part 3. make sure you put the face of the control on before you install it by the way make sure you unplug your range before you do anything. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Nut Drivers, Screwdrivers
Robert M Pensacola , FL March 26, 2016 Lightning strike damaged the mother board Simply removed the back of the range behind the motherboard and buttons, removed 4 screws and 2 electrical connectors to get the motherboard out. You have to peel the faceplate off of the old one, it's glued on but is not hard... takes a little time and patience. Stick the faceplate on the new unit and reverse procedure. No need to pay someone else. Unplug the range of course. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Nut Drivers, Screwdrivers
Elizabeth H Lumberton , MS March 11, 2019 Control board Replacement Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes