Emily H Sun City , AZ January 23, 2018 Range controller ailed rapidly flashing ordered replacement. Pull range out. Disconnect power cord. Remove 6 screws from top back panel Remove 4 screws from controller Disconnect 3 electrical connectors. (They Are distinctive and cannot be confused). Hook the connectors to the new unit. Refasten with the 4 screws and place The schematic ( self adhesive) Reinstall back top panel with the 6 screws Reconnect to power. Read More... 2 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Nut Drivers, Screwdrivers
Peter E Waldoboro , ME November 15, 2019 Control panel relay burned out, caught fire rev c Replaced with a new part from this site. It wasn't clear that the new control panel did not come with laminate face cover so I had to remove that from old panel and glue to new control panel. The new panel is Rev. H and has some clear changes, one being the buzzer to let you know when the oven is pre-heated or timer is going off. The removal and install were very simple. Read More... Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Screwdrivers
Chery M Valrico , FL February 06, 2021 F11 error code. Purchased a new control board. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Steven J Virginia Beach , VA June 04, 2019 Controller card burnt up. I bought a new controller card and film and replaced it in about 5 minutes with a screwdriver and nut driver. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Nut Drivers, Screwdrivers
Richard M Wadsworth , OH October 29, 2023 Oven not heating. YouTube it, checked a few things and the problem was control board. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Nut Drivers, Screwdrivers