Frigidaire 5304475599 Dishwasher Door Gasket OEM Part

The gasket is fairly straightforward: it's just a press-fit right in to the channel. What you need to know is that you need to stretch the gasket material lengthwise prior to installation; if you don't it will be too short. The problem is that the bottom seal is not included with this gasket kit. The bottom seal begins to loosen at the corners and then begins to allow water past the door. The only way the bottom seal is sold is as part of the inner door assembly, which is costly. I removed the inner door, removed the bottom seal, (which was almost falling out), and then cleaned it and the channel it sits in thoroughly. Next I used a very small pry bar to open the channel slightly to re-seat the seal lip. I used RTV in the channel and then re-clamped the metal lip at intervals with vise-grips. I used a series of small clamps to squeeze the seal while the RTV set up. I applied a second layer of RTV to the edge of the seal where it enters the metal channel to deflect any water that might work it's way in. The only downside to this repair is some cosmetic distortion at the bottom of the inside of the door-you can see the "bite marks" from the vise grips but this is only on the inside of the door at the very bottom. It is unreasonable to be forced to buy the entire inner door assembly.

The gasket was damaged already so I replaced it, but I also followed the advice from John H from Ozark MO on the seal at the bottom of the door. I agree that it is a little nuts that you have to buy the entire inner door panel to replace the bottom seal. So far so good.

Pulled out old (damaged) gasket, cleaned track, installed new gasket.

I had to replace the gasket. I'm not a handy person but thanks to the repair videos from appliancepartpros I could do this is no time. Now my wife is happy and I saved a lot of money.

Pretty easy fix for the gasket. Put on some rubber gloves. Pull out the old gasket (it just sits in there by friction). Stretch the new one out per another commenter. Push the new one into the groove. I folded mine in half and started from that point at the top middle to get it as close to even on both sides as possible. It still was a little longer on one side due to differences in how i pulled while putting the new one in. So far no leaks though. Thankfully I did not have to mess with the part at the bottom of the door. As for the cutlery basket, my original one was the 3 piece unit with a slotted lid in the middle. The new one is a one piece unit with slotted lids on each end. The new one is smaller. which is fine as it actually does a better job of getting the cutlery clean.