Frigidaire Washer Dryer Combo Gasket & Seal

This air duct seal creates a tight barrier between the dryer's lint housing and cabinet. Replacing a worn seal helps prevent air leaks, maintain proper airflow through the lint filter, and restore consistent drying performance.

• Seals the air duct/lint housing to the front panel to direct airflow through the lint screen and drum
• Helps maintain dryer efficiency and temperature control by preventing bypass air leaks
• Common symptoms of a failed seal include longer dry times, weak exhaust airflow, excess lint inside the cabinet, or lint around the door opening
• Replaces a deteriorated or missing seal to restore the intended air path

• Disconnect power; shut off gas supply for gas models
• Access the air duct by removing the lint screen and top/front panels as needed
• Remove the old seal and any residue; clean mating surfaces before installing the new seal
• Seat the duct evenly against the panel when reassembling to ensure a uniform seal

Seals the blower housing to prevent air leaks and maintain efficient airflow. Replace if torn, damaged, or causing reduced drying performance.

This is a rubber lip seal that fits around the upper portion of the washer's basket drive tube, preventing water from leaking past the shaft and into the transmission or bearings below. It creates a watertight barrier between the wash tub and the drive mechanism. Replace this seal if you notice water leaking from beneath the washer tub, hear grinding noises during the spin cycle, or find oil residue under the machine.

Secures and seals your washer's drain hose connection to prevent leaks. Replace if cracked, brittle, or leaking. Confirm fit with your model number.

This is an oil seal that fits around the transmission shaft where it enters the gear case on a washer or laundry center. It prevents water from leaking into the gear case and keeps lubricating oil from leaking out. Replace this seal if you notice oil leaking from the bottom of the washer, water entering the transmission, or if the unit is making grinding noises during the agitate or spin cycle.

This is a rubber seal gasket that fits between the transmission gear case housing halves on a washing machine. It prevents gear oil from leaking out of the transmission assembly during operation. Replace this gasket if you notice oil leaking from the bottom of the washer or if the transmission is being disassembled for repair.

Seals the lint housing to prevent air leaks and maintain drying efficiency. Replace if worn, cracked, or causing lint buildup. Confirm fit with your model.

O-ring seal for washer dryer combos. Replace when leaking or worn to prevent water damage. Verify fit with your model number before ordering.

This replacement door gasket creates a tight seal around the refrigerator door to help keep cold air in and warm air out, protecting food and improving cooling consistency. What it does:

• Seals the door to reduce air leaks and prevent temperature fluctuations
• Helps stop frost and moisture buildup inside the fresh-food compartment
• Restores proper door closing and alignment when worn or torn
• Can reduce compressor run-time caused by air infiltration

• Disconnect power to the appliance before starting any work.
• Remove the old gasket and clean the channel before installing the new gasket.
• Start installing at one corner and work around the door, ensuring the gasket seats fully in the channel.
• If needed, gently warm the gasket to increase flexibility for an easier fit (use low heat and caution).