Parts for Caloric EHN3402W/P1143205NW: Front Control Panel, Ehn330 / 340 (Ehn3302w / P1142476nw) (Ehn3302w / P1143204nw) (Ehn3402w / P1143205nw) (Ehn3802l / P1143207nl) Parts

The infinite switch regulates power to your range or cooktop's surface element, letting you set heat from low to high. Replace a failed switch to restore dependable burner control and consistent cooking performance.

• Regulates on/off power cycling to the surface element based on the knob setting
• Helps resolve no-heat, stuck-on-high, won't-turn-off, or erratic/uneven heat issues
• Often controls the surface "on" indicator light circuit; failure may affect the light
• Installs behind the control knob and connects to the existing wire harness

• Disconnect power at the breaker; allow the appliance to cool completely
• Remove the knob and access panel to reach the switch
• Photograph wiring and transfer wires to the same labeled terminals (commonly L1, L2, H1, H2, P)
• Reassemble, restore power, and test multiple heat settings; check the element and wiring

This thermostat knob replaces a worn or broken control knob so you can set and change oven or range temperature settings easily. It restores a secure grip and clear position indication for safe, consistent control. What it does

• Fits onto the thermostat/control shaft to allow manual temperature selection
• Provides a stable, easy-to-turn grip when original knob is cracked, stripped, or missing
• Helps ensure accurate user input when the control pointer or index mark is aligned
• Commonly used when the knob will not stay on, spins free, or temperature settings are hard to select

• One replacement thermostat control knob

• Disconnect power to the appliance before servicing to avoid shock or injury
• Pull off the old knob (firm pull or use a flat tool if needed) and press the new knob straight onto the control shaft until seated
• Make sure the knob index lines up with the control pointer or detent positions for correct settings
• If knob does not seat or control still malfunctions, inspect the control shaft and replace the underlying control/thermostat assembly as needed

This factory fastener secures panels, trim, or brackets on your appliance. Replacing a missing or stripped screw restores a snug, rattle-free fit and keeps components aligned for proper operation and a clean, finished appearance.

• Fastens exterior panels, trim pieces, or internal brackets to the appliance chassis
• Replaces lost, damaged, or stripped hardware
• Helps prevent vibration, rattling, and gaps between parts
• Common signs you need this screw: missing hardware, loose or misaligned panel/trim, stripped head or threads

• Disconnect power before servicing; also shut off the gas supply
• Use the correct driver; start the screw by hand to avoid cross-threading
• Tighten snugly—do not overtighten to prevent stripping or cracking adjacent parts
• Repair or replace the mounting point before installing

Size: 10-24X5/16-NI

This machine screw is used across appliances to secure brackets, covers, and internal components. Replacing a missing or stripped fastener helps keep parts aligned and tight, reducing vibration and preventing loose or shifting assemblies.

• Provides machine-thread fastening for panels, brackets, and internal parts
• Helps eliminate rattling, vibration, and loose fits
• Restores proper attachment when the original screw is stripped, missing, or corroded
• Used wherever an 8-32 screw is specified in the service manual or parts list

• Disconnect power to the appliance; turn off gas/water if applicable
• Match the screw to the original location to confirm size and thread
• Start threads by hand to avoid cross-threading; use the correct driver
• Tighten snugly—do not overtighten to prevent stripping or cracking