Parts for Speed Queen LFNE5BSP115TW01: Front Panel / Door Seal Parts

Dissolves odor-causing residue and mildew buildup in washing machine tubs. Use every 30 washes to maintain freshness. Verify fit with your model.

Stainless steel Torx screw secures panels, console trim, and internal brackets on laundry centers and washers. Replace when missing or stripped.

Self-tapping pan head screw (10 x 5/8 in) for securing appliance panels, trim, and assemblies. Replace missing, stripped, or corroded fasteners.

This drip shield fits around the washer door lock to help direct water away from the lock assembly and surrounding electronics, reducing moisture exposure and prolonging component life. What it does:

• Protects the door lock and adjacent components by diverting water and condensation away from the lock area
• Helps prevent lock corrosion, intermittent lock faults, or moisture-related electrical issues
• Restores original routing of water away from sensitive parts after a damaged or missing shield is replaced
• Simple, passive protection—no electrical function

• One door lock drip shield

• Refer to the washer's service manual for the correct removal and reassembly procedure
• Replace only with the exact part number to ensure proper fit and protection
• Disconnect power and water supply before accessing the lock assembly to avoid shock or flooding
• If corrosion or lock damage is evident, inspect and replace affected components as needed

Secures washing machine hoses and door boots to prevent leaks. Replace when clamp loses tension or shows rust. Verify size matches your hose diameter.

This door seal assembly creates a tight, durable seal around the appliance door to help keep heat and air inside the cabinet for efficient operation and consistent drying. It replaces a worn or damaged seal to restore proper door closure. What it does:

• Seals the gap between the door and cabinet to reduce air and heat loss
• Helps maintain consistent drying performance and cycle efficiency
• Prevents lint, moisture, and debris from escaping the drum area
• Reduces door-edge rubbing that can cause fabric wear or damage

• Disconnect power to the appliance before beginning any work.
• Inspect the door opening and gasket mating surface; clean away lint or residue before installing.
• Ensure correct seal orientation and full seating around the door perimeter; use existing clips/screws if applicable.
• After installation, run a short test cycle to verify the door closes properly and there are no leaks.

Black door boot seal creates a watertight barrier between the door and tub on front-load washers. Replace when worn or torn to stop leaks. Verify fit.

Dissolves odor-causing residue and mildew buildup in washing machine tubs. Use every 30 washes to maintain freshness. Verify fit with your model.

Damaged or worn control panel trim making your laundry center look unsightly? This front panel restores appearance and protects controls from debris.

Hex washer head screw for dryers and laundry centers. Secures panels, components, and internal parts. Replace if stripped, missing, or damaged.

Self-tapping hex washer-head screw secures panels and components in laundry centers. Replace when stripped or loose to maintain stability. Verify fit.

Access panel assembly for laundry center units. Covers internal components and provides access for maintenance. Replace if cracked, damaged, or missing.

Dissolves odor-causing residue and mildew buildup in washing machine tubs. Use every 30 washes to maintain freshness. Verify fit with your model.