Parts for Ge GTD81ESPJ0MC: Front Roller Support Parts

Package of 12

The Roller Assembly Wheel is an OEM part for GE dryers. It supports the drum and allows it to rotate smoothly during drying cycles, ensuring efficient and quiet operation. The assembly includes the roller, roller axle shaft, and two retaining clips. The roller is threaded on one side and hexagon-shaped on the other, with a tri-ring included for secure installation.

You should replace this roller assembly wheel if it becomes worn or damaged. Common causes of a bad roller assembly wheel include wear and tear from regular use, accumulation of lint and debris, or damage due to overloading the dryer.

Symptoms of a bad roller assembly wheel include:

• Thumping or squeaking noises during operation
• The drum not rotating properly or getting stuck
• Uneven drying of clothes
• Excessive vibration or movement of the dryer

This GE replacement part is also compatible with Hotpoint, RCA, and some Kenmore models.

This lint filter assembly traps lint and fibers from the exhaust airstream to maintain proper airflow and drying performance. Replace a torn or missing screen to help restore efficiency and reduce lint buildup inside the appliance and vent. What it does:

• Screens lint and debris from air leaving the drum
• Helps maintain airflow for consistent drying
• Helps keep lint out of the blower and vent path
• Common signs it's time to replace: torn mesh, cracked/warped frame, poor fit, excessive lint beyond the filter, longer dry times

• 1 lint filter assembly

• Disconnect power before service and allow the unit to cool
• Remove the old filter; vacuum/clean the lint housing and chute
• Insert the new filter fully and ensure it seats and moves smoothly
• Do not operate the appliance without the filter installed

This Dryer Grid Assembly is an OEM part for GE dryers. The grid assembly helps to filter out lint and debris from the air exiting the dryer, ensuring efficient operation and reducing the risk of overheating or fire hazards. 

The need for replacement of the dryer grid assembly can be due to accumulation of lint, physical damage, or general wear over time. A malfunctioning or clogged grid assembly can affect the dryer's performance and safety.

Symptoms of a bad Dryer Grid Assembly include:

• Excessive accumulation of lint beyond the lint trap.
• Reduced drying efficiency, leading to longer drying times.
• Unusual amounts of heat coming from the dryer.
• Potential risk of overheating or fire hazards.
• Visible damage or wear to the grid assembly.

This GE OEM replacement part is also compatible with Hotpoint, RCA, and some Kenmore models.
 

This replacement screw secures appliance panels and internal components per your model's hardware list. Replace lost or stripped screws to keep assemblies tight, reduce vibration and rattles, and maintain proper alignment.

• Fastens brackets, covers, and sheet-metal panels as specified in the parts diagram
• Restores proper fit when an original screw is missing, stripped, or damaged
• Helps eliminate rattling or vibration from loose hardware
• Keeps components safely in place during operation

• Disconnect power to the appliance before servicing
• Match length, head style, and thread to the original; install in the same location/quantity
• Start threads by hand to avoid cross-threading; tighten with the correct driver
• Do not overtighten, especially into plastic or thin sheet metal

This left-side sensor rod detects internal temperature and relays readings to the appliance control so the unit can maintain proper cooling and defrost cycles. Replaces a failed or damaged left temperature-sensing rod. What it does:

• Senses internal temperature at the left side and sends a signal to the control board
• Helps the appliance maintain correct cooling and defrost timing
• Common symptom: inconsistent temperatures, unit running too often, or food freezing/thawing unexpectedly

• One left-side sensor rod

• Always unplug the appliance or shut off power at the breaker before starting work
• Handle the sensor carefully; avoid bending or kinking the rod or wiring
• Verify connector orientation and seating; ensure the terminal is secure but do not force