Parts for Kitchenaid KHGV01RSS0: 03 - Front / Toe Panel And Burner Parts

This rubber grommet cushions and protects openings where wiring or components pass through panels, helping prevent chafing and reducing vibration for quieter operation. It's a simple replacement that restores proper fit where the original grommet is worn or missing. What it does:

• Protects wires and cables from abrasion where they pass through sheet metal or plastic openings
• Reduces vibration and rattling caused by loose or degraded mounting points
• Helps maintain correct component spacing and fit
• Common symptom: visible cracking, deformation, or a loose fit around a hole
• Common symptom: rattling or chafing noises near the damaged area

• One rubber grommet

• Disconnect power to the appliance before working on panels or wiring
• Installation may require removing the access panel or trim to reach the mounting hole
• Press the grommet into the opening until fully seated; ensure wires sit in the grommet channel without pinching
• Inspect surrounding wiring and fasteners for wear while replacing the grommet

This replacement gas valve controls gas flow to the burner in a gas dryer, enabling safe ignition and consistent heat. When it fails, the burner may not light and loads can stay damp; replacing it restores proper drying performance.

• Opens and closes gas flow to the burner when heat is called for
• Shuts off gas when the cycle ends or heating is not active
• Common symptoms: dryer runs but has no heat or the burner never ignites
• May present as the ignitor glowing or clicking repeatedly without flame, or intermittent heat

• Disconnect power and shut off the gas supply before servicing
• Work in a ventilated area and allow the dryer and burner to cool
• Use only gas-rated thread sealant on threaded connections
• After installation, turn on gas and check all joints for leaks with a soap-and-water solution

The Natural Gas Orifice is an OEM part for Whirlpool dryers. This part regulates the flow of natural gas to the burner, ensuring efficient and safe combustion for proper drying performance.

Causes of a bad natural gas orifice can include buildup of debris or lint, wear and tear over time, or damage from improper handling during maintenance.

Symptoms of a bad dryer natural gas orifice include:

• The dryer not heating up
• Inconsistent or weak flame in the burner
• Longer drying times than usual
• Unusual gas odors or hissing sounds

This OEM Whirlpool part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper and some Kenmore models.

This replacement mounting screw secures appliance panels and small components to restore proper fit and reduce movement. It's a simple, direct part for repairing loose panels, trim, or interior assemblies. What it does:

• Fastens panels, brackets, or assemblies to prevent rattling and vibration
• Restores proper alignment for doors, control panels, or trim pieces
• Helps stop intermittent noise caused by loose hardware
• Use when original screw is missing, stripped, or corroded

• Disconnect power and unplug the appliance before beginning any repair
• Use the correct screwdriver bit and hand-tighten; avoid over-torquing which can strip threads
• Keep small parts away from children and pets; magnetic tray helps prevent loss
• If multiple screws are corroded or hardware threads are damaged, inspect mating parts and replace as needed