Garbage Disposal Clip Or Clamp

The Sink Flange Mounting Kit is an OEM part for GE garbage disposers. As a complete kit, it contains the necessary sink flange rings, gaskets, seals, and mounting hardware to properly install or replace a disposer unit under the kitchen sink. Securely fastening the flange to the sink drain opening, affords a sturdy connection point for attaching the disposer mechanism.  

Symptoms of a bad or worn-out sink flange mounting kit include:  

• Looseness, wobbling, or movement of the disposer unit when in use
• Leaks detected around the flange seal or mounting area  
• Strong vibrations being transmitted to surrounding sink components
• Difficulty removing or installing the disposer due to improper fitting

This OEM GE replacement kit prevents any installation issues by providing all new mounting pieces engineered to specification. Compatible brand disposers also include InSinkErator, Badger, Waste King, and selected Kenmore models.
 

This clamp secures flexible hoses and small-diameter tubing to fittings, helping prevent leaks and maintain proper fluid flow in appliance systems. It's a simple replacement that restores a tight, reliable connection. What it does

• Holds a hose or tube firmly on a barb or nipple to stop leaks and loss of pressure
• Keeps water, drain, or vent hoses seated during normal appliance operation
• Replaces worn, corroded, or loose clamps that cause dripping or poor connections
• Works where a small, durable clamp is required for routing or securing tubing

• One hose clamp

• Inspect hose and fitting for damage; replace hose if cracked or hardened before installing the clamp
• Tighten clamp until snug—do not overtighten; ensure even compression around the hose
• Disconnect power and water as appropriate and take safety precautions before working on the appliance

This snap ring (circlip) secures a shaft or component in a groove to prevent axial movement, helping keep assemblies aligned and running smoothly. It's a small but critical retention part for appliance mechanisms. What it does:

• Holds bearings, shafts, or retainers in place by locking into a groove
• Prevents axial movement that can cause wobble, noise, or misalignment
• Maintains proper spacing of moving parts for reliable operation
• Common symptom: loose or shifting component, increased play or noise near the affected area

• One snap ring (circlip)

• Install with proper snap-ring (circlip) pliers to avoid deformation or injury
• Ensure the groove and ring are clean and free of debris before seating
• Inspect the ring for damage or wear; replace if distorted or cracked

This small retainer clip secures trim, panels, or components to keep appliance parts aligned and stable during normal use. It helps prevent panels from coming loose and reduces vibration or rattling. What it does:

• Holds panels, trim pieces, or brackets in place to maintain proper fit and alignment
• Prevents parts from shifting or vibrating during operation
• Addresses symptoms like loose trim, rattling noises, or panels that won't stay seated
• Works as a replacement for worn, broken, or missing clips that no longer secure components

• One retainer/mounting clip

• Turn off power to the appliance before attempting repair to avoid injury
• Remove adjacent panels or trim as needed to access the clip location; use appropriate hand tools
• Replace the clip by aligning it with the mating groove or hole and snapping or sliding it into place until seated
• If multiple clips are damaged, replace all affected clips for a secure fit

This grinding ring is the wear surface for the appliance's grinding assembly, replacing a worn or damaged ring to restore normal grind performance and reduce noise from metal-on-metal contact. What it does

• Serves as the replaceable wear surface inside the grinding chamber
• Helps maintain proper clearance between grinding components
• Commonly replaced when you hear excessive grinding noise or reduced grinding efficiency
• Can prevent further damage to mating grinding parts by restoring proper contact surfaces

• One grinding ring

• Disconnect power to the appliance before starting any disassembly
• Removal requires partial disassembly of the grinding chamber; follow the OEM service manual
• Use gloves and eye protection to avoid sharp edges and debris