Parts for Magic Chef 64HN-4TKVW-EV: Gas Controls Parts

This factory fastener secures panels, trim, or brackets on your appliance. Replacing a missing or stripped screw restores a snug, rattle-free fit and keeps components aligned for proper operation and a clean, finished appearance.

• Fastens exterior panels, trim pieces, or internal brackets to the appliance chassis
• Replaces lost, damaged, or stripped hardware
• Helps prevent vibration, rattling, and gaps between parts
• Common signs you need this screw: missing hardware, loose or misaligned panel/trim, stripped head or threads

• Disconnect power before servicing; also shut off the gas supply
• Use the correct driver; start the screw by hand to avoid cross-threading
• Tighten snugly—do not overtighten to prevent stripping or cracking adjacent parts
• Repair or replace the mounting point before installing

Oven won't heat or ignite? This igniter kit solves slow heating and ignition failure in gas ovens. Moderate DIY repair in 30-60 minutes.

Oven won't heat or ignite? This igniter kit solves slow heating and ignition failure in gas ovens. Moderate DIY repair in 30-60 minutes.

Hand-tighten wing nut secures panels, brackets, and components in ranges and ovens for tool-free adjustment. Replace when lost, stripped, or broken.

Replacement mounting screw for securing handles, panels, and internal components. Needed when original screws are stripped, lost, or broken during repairs.

This infinite switch controls an electric cooktop's surface burner by varying power to the element, letting you dial in and maintain precise heat. Replacing a failed switch restores smooth temperature adjustment and reliable simmer-to-boil performance. What it does:

• Regulates AC power to the surface element based on the knob setting
• Restores full range of heat levels from low simmer to high
• Common failure symptoms: no heat, stuck on high, erratic temperature, or burner won't turn off
• Can correct intermittent heating or a knob that turns without changing heat

• One surface burner infinite switch

• Disconnect power at the breaker before servicing
• Remove the control knob and access the console/panel to reach the switch
• Transfer wires to the matching terminals on the new switch; secure the switch to the panel
• Reassemble, restore power, and test the burner through all settings

For top surface burners. Configuration: 2 + 0.

Burners won't light? No spark on any burners? The spark module generates sparks to ignite gas burners. Easy DIY repair—usually takes under 30 minutes.