Ge WB04T10012 Cooktop Burner Gasket OEM Part

Replaced regulator replaced gasket

Second repair after 10 years of service - igniter had cracked and spill overs were causing the others to misfire. This was a two-step process. I took apart the cooktop to see what parts were neded. Screws were all rusted, I had to drill ome out. The burner gaskets broke during the process and needed replacement. One of the burners had deformed due to excess heat. After that initial diagnose, I reassembled the cooktop without the igniters and ordered all the parts I needed. The second stage was easy since I had already learned which parts needed replacement and how. work finished with a good cleanup of th glass plate.

Well after looking the issue up on YouTube I first tried the cleaning of the burners no help. So I decided I needed to replace either the harness switch assembly or the spark module. I decided that since I had to remove the glass top and install either and put if all back together before I would know if it worked, I just did both at once since it seemed it had to be one or the other. Got the parts ordered for the correct model, turned off the gas and pulled the top. Took about 90 minutes, really pretty easy step by step worked like a charm. I figured I save at least $200 to $250.00 for service call labor and parts. But it was finished at least a week before I could get a repair tech there.

Wellll, first we called an appliance repairman provided through the insurance plan. After several tries he put his hands in the air and basically stated that it would never work. So, I looked around and found appliancepartspros.com and looked at the diagrams and parts lists provided. A few days later the new spark module and spark wires arrived. After less than an hour the parts were in and we were firing on all four burners.

Used a small torx or star head driver to remove the plate hiolding the old igniter. Pull plate up and slide off the electrical wire from the old ignite. Removed the old igniter. Intalled the new one. Removed the old gasket and installed the new one. Slid electrical wire onto new igniter. Reassembled the plate to the cooktop. Malfunctioning ignter resolved! Whole repair took about ten minutes with the removal and installing of the sliding ring washer that holds the igniter to the plate being the trickiest part of the repair.