Kenneth S Lindenhurst , IL March 08, 2017 Loud whirring noise on spin cycle Replaced transmission and support assembly. Hub nut corrode on support, spanner wrench would not loosen. Had to use 1 11/16 deep socket and impact wrench to remove, basket would not com off support even after cleaning out and soaking with penetrant and using automotive air hammer to push out. I had to cut support plate in half with die grinder, cut bearing from shaft and punch out agitator shaft then use die grinder with carbide burr to cut basket shaft in two before basket would come off shaft. I am an experienced automotive technician with 40+ years and this job is not for the average DYIer if the nut and basket look corroded after removing the agitator Read More... 25 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 2+ hours Tools: Screwdrivers, Socket Set, Wrench Set
Eddie P Charlotte , NC May 04, 2019 Washer belt broken Replaced with new one Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes
Floyd S Millry , AL June 26, 2023 Worn drive belt. Ordered the replacement belt. Arrived in minimum time and was easy to install. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes