Kenneth B Glasford , IL November 17, 2020 Washing machine would not drain or spin. Replaced the lid lock 1st which fixed the lid not closed error but the machine would still not drain or spin. Replaced the control board next and now the machine works as it should. Read More... 31 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Nut Drivers
Joe S Socorro , TX December 24, 2022 Belt Replace belt. Read More... 4 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Nut Drivers
Thomas R Goshen , NY December 31, 2023 Appliance: General Electric Washer GTW680BSJ4WS Multiple error codes. The unit was not switching from wash to spin. I changed the washer mode shifter cleared all the codes and ran it through all the test. It agitated and spun no issues but would still not switch from wash to spin. Although it says not to do it I placed a wet towel in the basket and ran the spin test again and it worked no issue I then ran the machine on a normal cycle and it functions fine, no issue since. I’m unsure of the reason for this but a win is a win. The new shifter was easy to install and you only need a 3/8 inch ratchet with an extension. Read More... 4 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Socket Set
Phillip M Sapulpa , OK November 10, 2021 Appliance: General Electric Washer GTW485ASJ1WS Becoming out of balance on spin cycle and not spinning all the water out. Replaced suspension rods and drive belt. 30 mins to change all the parts out and running like new. Read More... 3 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Nut Drivers, Pliers, Screwdrivers
Charles S Keyport , NJ January 08, 2024 Appliance: Model GE GTW680BSJ5WS Failed drain pump. Broken belt and speed sensor. Ordered and removed/replaced all broken/failed parts. Took me about 15 minutes, maybe 20 as the little clip that holds the wiring in place for the speed sensor wasn’t coming out. After re-assembly I ran the remaining water out in a spin/drain cycle, then ran a small load of laundry. The washer runs just as good as new. Saved me quite a bit of money. If you can do any repairs yourself, then by all means save yourself the money and do it. I would 100% order from AppliancePartsPros.com again if needed. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Pliers, Screwdrivers, Socket Set