Ge WB14T10005 Hinassembly (Right) OEM Part

I always save original books and assembly sheets for appliances. That helped a lot ! The assembly sheets showed how the ovens went in, how they were attached to the cabinet and what to avoid so I didn’t bend trim piece. Original booklet showed how to replace oven doors and lights etc. Once the hinge assemblies arrived I started replacement after having read on the internet original hinges had some problems. So I had ordered both right and left hinges to avoid a possible problem with the second original hinge. Beginning the process I removed both upper and lower oven doors and all the racks and threw the breaker to disconnect the electricity. Then removed eight wood screws (4 in each oven) allowing the double ovens to be slid forward and exposing the hinges. Removed 4 screws for each hinge with 1/4 inch nut driver and by opening the hinge to the first stop (broiler position) I easily removed the good hinge. The broken hinge took some persuasion to hold in the broiler position for removal. I could have cut the spring or tried to remove it from the assembly if I had to to make it easier but that meant a trip to my shop so I just muscled it out. Four screws with nut driver attached each new hinge mechanism, slid ovens back into cabinet and attached ovens to cabinet with 8 wood screws. Replaced oven bulbs with new ones and cleaned glass bulb covers. Replaced racks, doors and trim piece on lower oven. Went to breaker box to flip circuit breaker. Reset clock. Total time 20-30 minutes start to finish.

Very simple to repair. The oven door very easily, although a bit heavy, slide off the hinges by opening the door to the first or broil stop and grabbing by the sides and lifting straight up. Installs in reverse order. Remove the eight small screws holding the entire oven in place in the wall. Pulled the entire oven (both top and bottom are one piece) out of the wall approximately six to eight inches. Remove the four screws holding the hinge in place, pulled out old hinge and installed new one in reverse order. The h Whole process took less than 15 minutes..

Replace with both new one, there are the original parts the i replace, they were both poor design by GE. The roller are very weak, they don't last. The new ones are a lot better.

Ordered part and watched video for repair. I would have paid a repairman $400.00 and I repaired it myself for the cost of the part. Love doing this kind of stuff!

We replaced the broken door hinge.