David F Willmar , MN January 02, 2022 The tabs were broke off so washer arm wouldn't stay secure. Replaced part and fixed the dishwasher. Read More... 3 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes
Daniel W West Hills , CA November 19, 2026 Appliance: General Electric Dishwasher PDT715SYN4FS The dishes weren’t getting clean in the top rack or the upper tray The dishes were clean on the bottom of the machine, but not on the top. The bottle washer still did a good job. I didn’t think it was a bad pump, since parts of the system worked. I guessed that the trouble had to be from bad water pressure. The water must be coming out somewhere else before it gets to the top. The thing that made me decide to replace the sprayer arms and their connection piping was that the old upper and lower spray arms came off too easy. I decided that these assemblies must be worn out. I guessed correctly and now the dishes are getting clean on the top rack and in the upper tray. After the repair, I could hear the water spraying around the inside louder than before the repair. This fix was easy. Most of the parts snap in. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Nut Drivers
Erick E Elk Grove , CA September 17, 2020 Appliance: Model GDT6955SSJ0SS Seals on rear of mid blaster assembly no longer sealed to docking port. Replaced docking port and mid blaster assembly. Docking port held in by 2 clips on back wall of dishwasher and mid blaster held in by singlr clip on top of unit. Repair took about 30 seconds. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes
Ross B Tamarac , FL July 18, 2020 Mid blaster broke where it connects to spinner. Bought new part from you guys that day. A couple days later the part arrived. I removed top shelf and swapped part out. It was very easy, took 10 minutes. Part was an exact match to existing part. Ran dishwasher that night with no problems. Thanks AppliancePartsPros.com! Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Joseph A Millsboro , DE September 12, 2019 Appliance: General Electric Dishwasher PDT825SSJ2SS Spinner broke off the bottom of GE dishwasher rack Found the connector that held the spinner wheel had cracked. Considered epoxy it back on and realized it would be difficult to secure during the set period. Also easily found the cracked part on your website and it only cost $28. Received part in 3 days over the weekend. Took 10 minutes to replace. The wife said the first load cleaned dishes very well. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes