Igor K Fair Lawn , NJ April 26, 2016 Appliance: General Electric Electric Range PP972SM1SS One burner stopped working due to short circuited control the seal over time started to allow the liquids to go down the control shaft causing the short Disconnected ( already tripped) breaker in the panel. Lifted cooked top unscrewed the glass top and set aside. I took the picture of the wires connected to the control on my ipad and replaced broken control. reconnected the wires as per picture. Cleaned the greased glass top and replaced the infinite switch seal for the broken control. Then reinstall glass top back on the cooktop and put the cooktop back in in place. Enable breaker in the panel and now i have good working cooktop again. ( do not rush and follow the replacement video on the site) Read More... 5 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Screwdrivers, Socket Set
Charles P Sparta Township , NJ June 25, 2019 Appliance: General Electric Electric Range JSP46DP1BB Burner switch not working. Myself using parts diagram. Read More... Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Screwdrivers, Socket Set
Steven P Ewa Beach , HI March 23, 2021 Appliance: Model GE JSP42SN4SS One burner on our GE range could not be controlled, it only ran at the highest setting regardless of where the knobs were set After a bit of research and watching YouTube videos, I ordered a new infinity control switch. The replacement of the switch was very easy and saved an expensive repairman visit. Read More... Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers, Socket Set
Hans G Aventura , FL July 10, 2023 The cooktop was not functioning. I took off the glass top and replaced the switches. Now is working perfect. Read More... Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Screwdrivers
Bryan H Spanish Fort , AL September 06, 2015 Appliance: Model JSP42BOK4BB Switch metal knob stem broke Unplugged range! Took the knobs off. Unscrewed the plastic hex covered with chanel locks. Popped the digital cover off with a screwdriver. Used a screwdriver to unacrew the switch. Used anutdriver to unacrew four screws on the metal housing. Took a photo of the wiring for later reference. Took one wire off at a time and put it on the new unit one at a time. Very easy! Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Nut Drivers, Pliers, Screwdrivers