General Electric Trash Compactor Parts

Wire clip secures wiring in your trash compactor. Replace if damaged, loose, or causing wire exposure. Verify fit with your model number before ordering.

Replacement rear guide for trash compactor door latch assembly. Aligns and supports the latch mechanism for secure closing. Needed when original is cracked or worn.

Mounting bracket for trash compactor top limit switch. Secures switch in correct position. Replace if bracket is bent, broken, or missing hardware.

Rotary switch knob for trash compactor control panel. Replace this dial if the original is cracked, broken, or missing to restore proper operation control.

This latch plate assembly secures the dryer door and engages the door switch so the machine can run. It restores proper door closure and helps ensure the dryer starts and runs safely. What it does:

• Provides the metal strike for the door latch to catch and hold the door closed
• Engages the dryer door switch so the appliance recognizes a closed door
• Commonly used when the door won't stay closed, the dryer won't start, or the door strike is bent or worn
• Fits into the door frame and works with the latch mechanism to restore secure closure

• Disconnect power before installing to avoid shock or injury
• Removal typically requires opening the dryer door and replacing screws that hold the plate to the door frame
• Check the mating latch for wear and alignment; adjust as needed for smooth operation

This slide track shield protects the compactor's track mechanism from debris and damage. Replace if cracked, broken, or missing to restore proper coverage.

Replace your compactor's worn, cracked, or broken handle assembly. This exterior handle mounts to the front panel for smooth opening and closing.

Replacement handle assembly for your compactor. Installs on the front door panel. Order a new handle if yours is cracked, broken, or missing.

Right-hand frame slide for trash compactors. Guides the ram during compaction cycles. Replace if cracked, bent, or causing misalignment issues.

Replace the toe kick panel assembly on your trash compactor. Covers the bottom front base area. Ideal when the original panel is cracked or damaged.

Toe kick panel for trash compactors. Installs at the base of the unit to cover the bottom gap. Replace if cracked, dented, discolored, or missing.

Tinnerman nut clip secures components in your compactor or hood. Replace if loose, damaged, or missing to maintain proper assembly. Verify fit with model.

Hex keps nut for compactor or hood assembly. Replaces missing, stripped, or corroded fasteners. Secures internal components during installation.

Replacement drive chain for trash compactors. Connects the motor to the ram mechanism. Order a new chain if yours is broken, stretched, or missing.