General Electric Trash Compactor Leg Or Foot

This frame roller assembly mounts to the appliance frame and supports a sliding drawer or rack. Replacing a worn roller restores smooth, aligned movement and helps reduce sticking or grinding noises during operation.

• Provides rolling support for the sliding drawer/rack along the frame
• Helps keep sliding components aligned to prevent binding and uneven travel
• Reduces friction for smoother, quieter operation
• Typical symptoms: hard-to-slide drawer/rack, wobbling or scraping, visible roller damage

• Disconnect power; turn off water supply before servicing
• Remove the drawer or rack to access the frame-mounted roller assembly
• Note orientation; transfer any reusable hardware and secure the new assembly in the same position
• Verify smooth, level travel before reassembly and returning to service

The Drawer Roller Asm is an OEM component specifically designed for GE Waste Compactors. This Drawer Roller Asm is responsible for safely guiding the compactor drawer in and out. By assisting the smooth opening and closing of the drawer, it helps reduce strain on the entire compactor system.

Causes of bad rollers can include excessive use over time, improper loading that puts undue stress on the rollers, or damage from impact or pinching. 

Symptoms of bad rollers include: 

• Difficulty opening or closing the compactor drawer 
• Excessive noise or grinding sounds when moving the drawer
• The drawer not sliding freely and securely on its rollers

This OEM GE replacement part is also compatible with Hotpoint, RCA, and some Kenmore trash compactor models.

This drawer wheel assembly replaces a worn or broken roller that supports a sliding drawer inside your appliance. It restores smooth, aligned movement so the drawer rolls in and out easily without binding, wobbling, or dragging.

• Supports the drawer's load and guides it along its track
• Helps maintain alignment to prevent binding or coming off-track
• Restores smooth, quieter roll-in/roll-out operation
• Common symptoms: stiff opening/closing, wobble or uneven glide, scraping noise, cracked or missing wheel

• Disconnect power to the appliance; also shut off water.
• Remove the drawer to access the wheel location and note orientation before removal.
• Remove fastener(s), install the new wheel assembly, and securely tighten; reuse existing hardware.
• Reinstall the drawer, check alignment, and test movement before returning to service.