Parts for Kenmore 158.13410 (15813410, 158 13410): Geared Cam Assembly Parts

This brass compression ring is a small tubing fitting component that helps form a tight, leak-resistant seal at a compression joint. It's used where a reliable metal-to-metal seal is needed for fluid or gas lines. What it does:

• Squeezes around tubing when tightened to create a compression seal at a fitting
• Restores a reliable connection when the original ring is worn, damaged, or deformed
• Helps prevent visible leaks or seepage at compression joints
• Maintains proper sealing for safe operation of fluid/gas lines

• One brass compression ring

• Only install on the correct tubing/fitting type and size; confirm fit before tightening
• Turn off and isolate the system and relieve pressure before disassembly
• Inspect mating surfaces and replace the ring if it is cracked, flattened, or corroded
• Tighten fittings per the equipment/OEM instructions; do not overtighten or reuse a damaged ring

This surface burner infinite switch sits behind the knob and regulates power to the cooktop/range element. Replacing a failed switch restores accurate heat settings so the burner can turn on, modulate properly, and shut off as expected.

• Regulates on/off cycling of the surface element to achieve the selected heat level
• Sends power to the burner based on knob position
• Common failure symptoms: burner won't heat, only runs on high, won't shut off, or heats erratically
• Knob turns but the burner does not respond

• Disconnect power at the breaker before servicing; surface elements operate at high voltage
• Pull off the knob and remove the control panel/backguard as needed to access the switch
• Transfer wires one at a time from the old switch to the matching terminals on the new switch
• Align the shaft to fit your knob, reassemble the panel, restore power, and test operation