Parts for Ge PFSS5RKZHSS: 05 - Ice Maker & Dispenser Parts

Replace your refrigerator water filter every 6 months to maintain clean water and ice. Removes contaminants for fresh taste. Easy DIY install in minutes.

8-18 CA HX 1/2 S

Mounting spacer maintains proper clearance between refrigerator panels, doors, or components. Replace if cracked, broken, or missing to restore fit.

This DC auger motor drives the ice-dispensing auger in the freezer door, restoring proper ice delivery from the dispenser. It replaces a worn or failed motor to get the auger turning again for reliable dispensing. What it does:

• Turns the ice auger so cubes or crushed ice move from the bin to the dispenser
• Stops common symptoms like no ice dispensed, intermittent auger movement, or a stuck auger when motor failure is the cause
• Operates as the motorized drive for the dispenser auger assembly
• Works with the existing auger shaft and housing when the motor is the failed component

• One DC auger motor

• Disconnect power to the appliance before starting any repair
• Access may require removing the freezer door liner or dispenser housing; keep fasteners organized
• Observe wiring connections and routing; transfer connectors exactly or document before disconnecting

This refrigerator ice maker assembly freezes water and automatically ejects cubes into the bin. Replacing a failed unit restores steady, hands-free ice production and helps resolve common ice maker cycling and cube-ejection issues.

• Freezes water in its mold, then harvests and drops finished cubes into the ice bin
• Controls fill and harvest timing for consistent cube production
• Typical failure symptoms: no ice production, unit stuck mid-cycle, cubes not ejecting, or loud clicking/grinding from the drive
• Works with the refrigerator's controls to pause ice making when the bin is full

• Disconnect power and shut off the water supply before servicing
• Remove the ice bin and any covers; unmount the old ice maker and disconnect its wiring harness
• Transfer any brackets, covers, or guides from the old unit if needed
• Mount the new assembly, reconnect wiring, restore power/water, and allow up to 24 hours for full ice production