Parts for Frigidaire RS24F9DX1C: 13 - Ice Maker And Ice Maker Installatio Parts

This spring-style hose clamp secures flexible appliance hoses and helps prevent leaks by holding hose ends tightly to fittings. Reliable, low-profile design for use on drain, water, or vent hoses where a strong, consistent grip is needed. What it does:

• Provides a spring-tensioned grip to keep hoses seated on fittings and reduce leaks
• Commonly used on flexible drain or water hoses and small vent lines
• Helps maintain proper connection under normal vibration and thermal cycling
• Replaces worn, stretched, or corroded clamps that no longer hold tension

• One spring hose clamp (exact quantity as sold)

• Use pliers to expand the clamp, slide into position, then release to seat on the fitting
• Inspect hose ends and fittings for wear; replace hose if damaged before installing clamp
• Wear eye protection when compressing the clamp; keep fingers clear of the clamp's edges
• Tighten only as needed—over-compressing can damage the hose

This replacement insulator cushions and secures appliance components to reduce vibration and noise for smoother operation. A simple, durable part that restores proper spacing and helps prevent rubbing or wear from vibration. What it does

• Cushions components to reduce vibration, rattling and noise during operation
• Helps maintain correct spacing and alignment of mounted parts
• Protects parts from wear by preventing metal-to-metal contact
• Commonly replaced when vibration or unusual noise is present

• One insulator

• Disconnect power (unplug or shut off breaker) before starting any repair
• Remove access panels or panels required to reach the original insulator
• Press or seat the insulator into the original mounting location; may require light hand force or basic tools
• Inspect surrounding mounting hardware and replace any worn clips or fasteners for a secure fit

This part has been discontinued by the manufacturer and is no longer available.

This part has been discontinued and is no longer available.

1/4"diameter - 93" long, plastic, cut-to fit