Parts for Frigidaire RS24F9DX1C: 12 - Ice Maker And Ice Maker Installatio Parts

This part has been discontinued by the manufacturer and is no longer available.

This replacement hinge spring helps the oven door open and close smoothly by restoring proper tension to the door hinge assembly. Replaces worn or broken hinge springs so the door stays balanced and moves without slipping. What it does

• Provides tension for the oven door hinge so the door opens and closes evenly
• Helps keep the door from falling open or slamming shut due to worn spring tension
• Restores correct alignment that can reduce rubbing or uneven movement
• Commonly replaced when door feels loose, drops, or doesn't stay in the desired position

• One hinge tension spring

• Disconnect power to the appliance and allow oven to cool before servicing
• Removing the oven door or loosening hinge brackets may be required for access
• Handle springs carefully; they are under tension — wear eye protection and follow factory service instructions

This tube clamp secures small tubing and lines inside the appliance to prevent movement and reduce wear. It keeps hoses and tubes routed properly so they don't rub against sharp edges or vibrate during operation. What it does:

• Holds water, drain or refrigerant tubing in place to prevent sagging and chafing
• Reduces vibration and rattling from loose lines
• Helps prevent tubing wear that can lead to leaks or pinch damage
• Keeps hoses routed neatly for reliable appliance operation

• Disconnect power and shut off water supply before beginning any repair
• Remove any access panels needed to reach the clamp location; use caution around sharp sheet metal
• Replace only the damaged clamp with the same style and secure tubing firmly but without over-tightening
• If tubing shows damage where it was rubbing, replace or repair the tubing before reinstalling the clamp

This water inlet valve controls water flow to the refrigerator's dispenser and ice maker, restoring proper filling and dispensing when functioning. Designed for direct replacement to stop leaks or restore water delivery. What it does

• Opens and closes water supply lines to the dispenser and ice maker using two solenoids
• Replaces a failed valve that causes no water or reduced water to the dispenser or ice maker
• Stops intermittent leaks or continuous flow caused by a stuck or damaged valve
• Works with the refrigerator's water pressure and electronic controls to meter fills

• One water inlet valve assembly

• Turn off water supply and unplug the appliance before servicing
• Inspect inlet screen/filters and supply line for debris when replacing valve

This part has been discontinued by the manufacturer and is no longer available.