Parts for Thermador KBUDT4875E/01: Ice Maker Parts

This Bosch filter removes contaminants and improves water taste. The filter should be changed every six months for best performance. Simple installation requires no special tools. Measures approximately 13.25" x 2.5" x 2.5".

This mounting bracket secures internal components to the appliance frame, restoring proper alignment and reducing movement. Designed as a direct-fit replacement to help stabilize parts that have become loose or misaligned over time. What it does:

• Provides a stable anchor point for panels, assemblies, or mechanisms that rely on frame support
• Reduces rattling, vibration, and shifting caused by worn or damaged mounting points
• Helps restore correct part alignment for smooth operation of moving components
• Compatible where the original stamped metal bracket is required for proper fit

• Bracket

• Install in the location and orientation shown in the appliance's parts diagram; refer to model-specific instructions
• Use the original fasteners when possible; replace any stripped or damaged screws
• Disconnect power to the appliance before attempting installation to avoid electrical or mechanical hazards

This valve controls water flow into the appliance, restoring proper filling and water delivery. Replaces a worn or leaking inlet/fill valve to help stop underfilling, overfilling, or continuous water flow. What it does:

• Opens and closes to allow water into the unit during fill cycles
• Stops water flow when fill level is reached to prevent flooding or overfill
• Commonly used when the appliance won't fill, fills slowly, or runs continuously
• Designed to mate with the appliance's water line and electrical connector

• One valve assembly (1 each)

• Disconnect power and shut off the water supply before replacing the valve
• Handle electrical connections and water fittings carefully; use proper tools and tighten fittings to OEM torque specs
• Inspect inlet hoses and fittings for damage and replace if needed to prevent leaks

A replacement heat exchanger that helps remove heat from the refrigerator cooling circuit so the appliance can maintain proper internal temperatures. Restores proper refrigerant flow and supports consistent cooling performance. What it does:

• Circulates refrigerant through the evaporator circuit to absorb heat from the fresh-food compartment
• Helps the system reach and maintain target cooling temperatures
• Commonly replaced when corrosion, leaks, or physical damage reduce cooling efficiency
• Required if symptoms include weak cooling, frost pattern changes, or visible refrigerant leakage

• Disconnect power and follow all safety procedures before servicing
• Inspect surrounding tubing and fittings for damage or corrosion; replace any compromised components
• Use proper leak-testing and vacuum procedures when recharging the system

This ice container is the removable bin that stores and collects ice produced by the refrigerator's icemaker, keeping ice accessible for dispensing and everyday use. Durable plastic construction lets you remove, refill, and clean the bin easily. What it does:

• Holds ice produced by the icemaker so cubes are ready when needed
• Guides ice toward the dispenser or access area for easy retrieval
• Helps contain melted water and reduces spills inside the freezer compartment
• Restores lost storage after a cracked, warped, or missing ice bin

• Unplug the appliance or turn off power at the breaker before removing or installing the bin.
• Slide the old bin out, then slide the replacement into place until it seats.
• Handle with care to avoid cracking the plastic; do not force if it does not align.
• Clean and dry the bin before reinstalling; follow manufacturer cleaning instructions for sanitizing.