Parts for Ge JVM1790BK01: 06 - Interior Parts (2) Parts

Fix a microwave that won't heat or has no power with this high voltage capacitor. Critical component requiring careful handling and discharge.

The Fuse is an OEM part for GE microwaves. It serves as a safety device designed to protect the microwave from excessive current that can cause overheating and potential fire hazards. When the current flowing through the microwave circuit exceeds a certain level, the fuse blows or breaks, cutting off the power to prevent damage or fire.

Common causes for a fuse to blow include power surges, faulty wiring within the appliance, or the use of microwave inappropriate containers that cause sparks. It is essential to address these issues not only to replace the fuse but also to correct the underlying problems to prevent future failures.

Symptoms of a bad fuse include:

• The microwave suddenly stops working.
• No signs of power or response even when the microwave door is closed and the start button is pressed.

This GE replacement part is also compatible with Hotpoint, RCA, and some Kenmore models.

Mounting screw that secures the power control module inside your microwave. Replace if screw is stripped, missing, or damaged during repairs or maintenance.

Replace your microwave's halogen light bulb when interior lighting dims or fails. Restores visibility for monitoring cooking. Verify fit with your model.

Lamp cover guard for microwave ovens. Protects the interior light bulb from grease and moisture. Replace if cracked, discolored, or missing. Installs over bulb.

Guide holder assembly for microwaves. Secures and positions the waveguide cover in place. Replace if cracked, broken, or missing to restore proper fit.

Fix a microwave vent fan that won't remove smoke or steam with this ventilation motor. Restores proper airflow to clear cooking odors effectively.

Microwave not heating on auto cook? This temperature sensor monitors internal temps for consistent heating. Restores accurate temperature control.

Duct component for microwave ventilation system. Directs air flow from cooking area to exhaust. Replace if cracked, damaged, or missing for proper venting.

This molded air tunnel directs heated air from the blower through the dryer drum for consistent airflow and efficient drying. Replaces a cracked or damaged duct to restore proper air circulation and help improve drying performance. What it does:

• Channels blower air into the drum and toward the lint screen and exhaust
• Prevents airflow loss from gaps or cracks that can reduce drying efficiency
• Helps maintain proper ventilation to reduce overheating and extended dry cycles
• Fits into the dryer's internal plenum to keep airflow focused and consistent

• One air tunnel/drying airflow duct

• Disconnect electrical power (and gas supply for gas dryers) before beginning service
• Access typically requires removing the dryer front panel or cabinet
• Align the tunnel with the blower housing and drum opening, then secure with the original fasteners or clips
• Check for a good seal around mating surfaces and reassemble panels before testing