Jenn-Air Range Hood Parts

This lower back panel replaces the damaged or rusted rear cabinet cover to protect internal components and keep the appliance stable. It restores the appliance's rear enclosure and helps prevent debris from entering the chassis. What it does:

• Covers and protects rear-mounted controls, wiring and components from dust and debris
• Restores structural enclosure at the lower back of the appliance cabinet
• Helps maintain proper airflow paths and prevents accidental contact with internal parts
• Reduces rattles or vibration caused by a loose or damaged rear panel

• One lower back panel

• Basic hand tools required; disconnect power and gas before starting
• Remove any obstructing panels or kickplates to access mounting fasteners
• Handle edges carefully — metal panels may have sharp edges; wear gloves
• If screws or clips are damaged, replace with OEM-specified fasteners for a secure fit

This motor housing secures and protects the appliance motor and helps keep the motor aligned for reliable operation. Replacing a damaged housing restores proper motor positioning and reduces unusual noise or vibration. What it does:

• Supports and locates the motor assembly inside the appliance
• Protects the motor from debris and contact with other components
• Helps reduce motor vibration and related noise when intact
• Keeps motor mounting points stable to prevent misalignment or rubbing

• One motor housing as shown

• Refer to your model's service manual or parts diagram for correct placement and fastener locations
• Disconnect power before starting any repair to avoid electrical shock
• Handle with care to avoid damaging mounting tabs, gaskets, or adjacent wiring
• Inspect and replace worn motor mounting hardware as needed for a secure fit

This panel light is the replacement lens that mounts over the appliance control console to protect and help illuminate the buttons and display for easier viewing. Restores visibility and a finished appearance to the control area. What it does:

• Covers and protects the control console while allowing backlight to shine through
• Helps improve button and display visibility when the console light is on
• Commonly replaced when the lens is cracked, discolored, or missing
• Reduces glare and prevents debris from reaching buttons and electronics

• One panel light lens

• Disconnect power to the appliance before any service to avoid shock
• Typically installs from the front of the console; common tools: screwdriver
• Handle lens carefully to avoid scratching; retain all fasteners for reassembly

This front control panel trim restores the appliance's exterior appearance and provides a proper mounting surface for controls and displays. It replaces damaged or worn front-facing trim to help keep buttons and indicators aligned and protected. What it does

• Covers and protects the appliance's control area from dirt, spills and wear
• Provides a secure mounting surface so buttons, knobs or displays sit correctly
• Restores a clean, finished look when the original panel is cracked, bent or discolored
• Helps prevent debris from entering internal control components, which can cause erratic operation

• Disconnect power (and gas if applicable) before starting any repair to avoid shock or injury
• Typical installation requires removing trim screws and detaching/control console components; keep track of fasteners
• Handle with care to avoid scratching the new panel during installation