Kenmore / Sears Range Hood Housing Or Cover

This scroll is the blower housing that directs airflow inside the ventilation blower assembly, restoring proper exhaust flow and helping reduce noise from an unstable blower. It fits into the blower motor assembly to channel air through the fan. What it does:

• Channels and directs airflow from the blower wheel to the exhaust duct
• Helps position and support the blower wheel for stable operation
• Worn or damaged scrolls can cause reduced airflow or poor exhaust performance
• Cracks, deformation, or loose fit may create vibration or unusual noise

• Disconnect power to the appliance before any service to prevent electrical hazard
• Installation typically requires removing the blower assembly and a few fasteners; keep track of screws and orientation
• Inspect the blower wheel and motor during reassembly; replace any damaged components
• Handle edges carefully and test operation after installation to confirm airflow and quiet operation

Replacement top panel for the unit's housing. It restores a secure cover over internal components and proper airflow containment when the original top is bent, cracked, or missing, helping the ventilation system operate as intended.

• Forms the upper cover of the housing and shields internal parts
• Helps direct and contain airflow through the unit
• Provides mounting or clearance for components and wiring pass-throughs as designed
• Typical failure signs: dents or cracks, air leaks, vibration/rattling, reduced airflow, or trouble aligning fasteners

• Disconnect power at the breaker before servicing.
• Support the hood/assembly and remove filters or covers as needed to access fasteners.
• Keep track of hardware; transfer any gaskets, clips, or components from the original top.
• Edges can be sharp—wear cut-resistant gloves; align and tighten fasteners evenly to avoid gaps.