This wire harness connects the control/switch assembly to the appliance's thermal cutoff and control circuits, restoring reliable electrical connections for proper operation. It's a direct-fit replacement when the original wiring is damaged or corroded. What it does:
- Provides the factory routing and connectors between the control/switch and TCB/thermal cutoff
- Re-establishes lost or intermittent power caused by damaged wiring or broken terminals
- Helps stop failures that cause controls to be unresponsive or cycles to stop unexpectedly
- Uses OEM-style terminals and insulation to match original fit and function
What's included:
- One wire harness (switch TCB) as shown
Install notes:
- Disconnect power before starting — verify the appliance is completely de-energized
- Take photos of existing wire routing and connector locations to ensure correct reassembly
- Plug connectors fully and secure the harness along original clips or tie points; avoid sharp edges
- If terminals are damaged at mating parts, inspect and replace those components rather than splicing connectors
Do-It-Yourself Stories from Customers like You
Gas range one burner stopped lighting when turned on James C. • Franklinton , NC • September 17, 2016
I researched similar problems online, especially youtube. The ignition harness seemed to be the problem. I ordered it here, and received it within 2 days. Maybe I was lucky, but It took only about 15 minutes to replace on my unit. Stove is back to working as expected.
Read more