Lg Range / Cooktop / Oven Parts

This door gasket assembly forms the seal around the appliance door to help keep interior temperatures stable and reduce energy loss. Replaces a worn or damaged seal to improve cold retention and reduce frosting. What it does:

• Creates an airtight seal around the door to help maintain proper temperature
• Helps prevent warm air and moisture from entering the compartment
• Reduces excessive frost or ice buildup caused by a leaking seal
• Can improve compressor run-time and cooling consistency when sealing is restored

• Unplug the appliance before starting any repair.
• Clean the door and gasket mounting surface before installing to ensure a proper seal.
• Gasket may require stretching, aligning, or temporary fastener removal; follow OEM instructions for best fit.

This radiant heater is the oven/stove heating element that provides consistent radiant heat for baking and broiling. Replaces a failed element to restore proper cooking temperatures and even heat across the oven cavity. What it does:

• Converts electrical power into radiant heat used for baking and broiling
• Heats up evenly to maintain oven temperature during cooking cycles
• Commonly replaced when oven fails to heat or heats unevenly
• A solution for visible element damage, open/short electrical readings, or blown fuses/tripped breakers related to the oven circuit

• Disconnect power to the appliance before servicing to avoid electrical shock
• Inspect connectors and mounting hardware; replace any damaged fasteners or wiring
• Handle the element carefully to avoid bending or damaging terminals

This front control panel replaces the damaged or unresponsive user interface on your appliance, restoring button and display access for normal operation. It mounts on the appliance exterior and connects to the internal control assembly. What it does:

• Provides the primary button and display area used to start cycles and select settings
• Replaces cracked, scratched, or otherwise damaged front panel surfaces
• Restores response when physical buttons or touch areas are worn or nonfunctional
• Helps eliminate erratic or missing readouts when the panel housing is the source of the issue

• Disconnect power (unplug or switch off circuit breaker) before starting any repair
• Handle the panel carefully to avoid glass or plastic damage and protect attached wiring
• Remove trim and mounting screws to access connectors; note connector positions before disconnecting
• Test the main control board and wiring harness for faults