Lg Range / Cooktop / Oven Parts

Middle Grate

Note: Due to factory variations, please check your original board before ordering. This display control board has 17 buttons on the front. If your original board has 18 buttons, you may need part# EBR89296404 instead.

The Display PCB Assembly is an OEM part for LG ranges and stoves. It is the main circuit board that controls the display panel and oven. This assembly is responsible for operating all electronic functions such as temperature controls, timers, buttons and digital displays.

Causes of a bad display PCB assembly can be water or liquid damage, failure due to surges or spikes in the power supply over time, or due to normal component degradation after heavy use.

Symptoms of a bad display PCB assembly include:

• Faulty or unresponsive control buttons
• Erratic temperature control functions
• Glitches or failures in the digital display
• Inability to operate certain cooking modes

This OEM LG part is also compatible with some Kenmore models.

The Common Nut is an OEM part for LG ranges. It secures the fan blade to the motor shaft. This nut maintains the fan's stability and preventing it from becoming dislodged during use.

Causes of a bad common nut can include loosening over time due to vibration, improper installation, or damage from impact or mishandling.

Symptoms of a bad common nut include:

• Excessive noise or vibration from the fan assembly
• The fan blade becoming loose or detached, causing poor air circulation
• Potential risk of the fan blade becoming a projectile if completely detached

This OEM LG part is also compatible with some Kenmore models.a

This hardware washer helps distribute fastener load and maintain proper spacing in your LG appliance. Replacing a missing or worn washer restores secure mounting and alignment, reducing vibration and rattling from loose assemblies.

• Distributes the load of a screw or bolt and protects mating surfaces to maintain alignment
• Helps keep components secure and at the correct spacing
• A damaged or missing washer can lead to loosening, vibration, or rattling during operation
• Ensures correct hardware stack-up during reassembly after service

• Disconnect power and shut off water or gas before servicing
• Note the order and orientation of any washers/spacers; take a reference photo
• Use the correct driver or wrench and tighten snugly—do not overtighten
• Replace companion hardware if corroded, stripped, or damaged