Lg Washer Dryer Combo Parts

This duct outlet directs dryer exhaust from the appliance to the home vent, helping maintain proper airflow and a finished connection. It replaces damaged or cracked outlets that can cause leaks, rattles, or restricted airflow. What it does:

• Provides a secure discharge path for exhaust air from the appliance
• Restores a sealed connection to the vent system to reduce leaks and lint escape
• Replaces cracked, warped, or broken outlet pieces that cause rattling or poor airflow
• Helps prevent airflow restriction that can extend drying times or stress the dryer

• Disconnect power and gas before servicing the dryer
• Work in a well-lit area and note existing vent/clamp orientation before removal
• Use gloves to protect hands from sharp sheet-metal edges
• Check and tighten clamps or seals after installation; replace any damaged vent hose or hardware

This ball bearing supports a rotating shaft in the drive system, reducing friction so the appliance runs smoother and quieter. Replacing a worn bearing can curb rumbling and help prevent damage to adjoining shafts, housings, or seals.

• Supports and centers a rotating shaft within the assembly
• Reduces friction and wear between moving parts for smooth operation
• Helps limit noise and vibration from the drive system
• Common symptoms of failure include grinding/roaring noises, excessive play or wobble, rough or stiff rotation by hand, or seized rotation

• Disconnect power and, if applicable, shut off water before servicing
• Access the bearing by disassembling the related housing; note orientation and order of components
• Press the bearing out/in with a driver or press; do not hammer on the inner or outer race
• Inspect the shaft and any companion seals or bearings; clean the bore and seat the new bearing fully

This clamp secures flexible hoses to fittings to prevent leaks and keep connections tight. It's a simple replacement that restores a secure seal on water and drain lines. What it does:

• Holds a hose firmly to a barb or nipple to prevent slipping and leaks
• Helps stop common symptoms like dripping, visible leaks, or a loose hose connection
• Keeps hoses from shifting or vibrating during operation
• Works wherever a small metal hose clamp is used on plumbing or drainage connections

• One clamp

• Turn off power and shut off water supply before replacing the clamp
• Slide the clamp over the hose, seat the hose on the fitting, then tighten or crimp per the clamp type
• Use pliers or the correct tool for the clamp to avoid damage to the hose or clamp
• Replace with the same clamp style and size for a proper fit; inspect hose and fitting for wear

This replacement balance weight helps stabilize the washer tub during spin cycles to reduce excessive shaking and banging. Restores proper weight distribution so the washer runs more quietly and completes cycles without heavy vibration. What it does:

• Adds counterweight to the washer tub to help balance loads during spin.
• Reduces shaking, banging, and excessive movement during high-speed spins.
• Can help prevent intermittent off-balance conditions and noisy operation.
• Works as a direct replacement for worn, cracked, or missing tub weights.

• Disconnect power and turn off water supply before beginning any repairs.
• Access may require removing the washer cabinet or front panel; follow the model-specific service manual.
• Wear gloves and eye protection; use appropriate tools and fasteners to secure the weight.

This replacement clamp secures flexible hoses and tubing to fittings to help prevent leaks and keep connections stable. It's a small but essential part for reliable water and drain line performance. What it does:

• Holds hoses or tubes firmly to barbs, fittings, or posts to prevent disconnection
• Helps reduce leaks and water seepage at hose connections
• Minimizes rattling or vibration from loose tubing
• Supports proper routing of lines to avoid kinks or wear

• Disconnect power and water supply before starting any repair
• Use appropriate hand tools (pliers or a screwdriver, depending on clamp type) and avoid over-tightening
• Inspect nearby hoses and fittings for wear and replace if damaged