Parts for Bosch NGM5664UC/01: Manifold / Valves Parts

This push-on retainer clip holds a 6mm shaft securely in place on compatible appliance components, restoring proper axial restraint and preventing parts from sliding off during operation. Simple, low-profile fastening for shaft retainment. What it does:

• Secures shafts and spindles with a 6mm outer diameter to prevent axial movement
• Keeps knobs, pulleys, or rotating components positioned correctly during use
• Commonly used where a quick, tool-free clip is required for retention
• Can resolve symptoms like loose or detached knobs, wobbling pulleys, or parts sliding along the shaft

• One push-on retainer clip sized for 6mm shaft mounting

• Push the clip onto the shaft groove until it snaps into place; ensure full engagement before operating
• Use snap-ring pliers or appropriate tools if removal is required to avoid damage
• Wear eye protection when installing or removing clips to guard against sudden release

The Spark Switch is an OEM part for Bosch ranges. This part ignites the burners by sending a signal to the spark module, which then produces the spark needed to ignite the gas.  

Causes of a bad spark switch can include wear and tear from regular use, damage from spills or cleaning agents, or electrical issues.  

Symptoms of a bad spark switch include:

• Burners not igniting
  Continuous clicking even after the knob is turned off
  No spark when attempting to ignite the burner
  The cooktop not producing a flame

This OEM Bosch part is also compatible with Thermador, Gaggenau, and some Kenmore models.

This replacement water inlet valve controls water flow into the appliance, restoring proper fill and preventing overfill or no-fill conditions. Designed to match the original OEM fit for reliable operation. What it does

• Opens and closes to allow water into the appliance during fill cycles.
• Helps correct symptoms such as no water entering, slow or incomplete fills, or continuous filling.
• Works with the appliance's control system to regulate fill timing and volume.
• Replaces a worn or leaking valve to stop water leaks at the inlet.

• One replacement water inlet valve as shown.

• Turn off power and shut off the water supply before beginning repair.
• Inspect inlet hoses and seals and replace any damaged components to prevent leaks.
• Mount and secure valve per OEM alignment; do not overtighten fittings.