Maytag Range / Cooktop / Oven Chassis Or Cabinet

This bottom oven is the lower oven cavity panel that supports baking and broiling in two-door ranges, restoring the oven's interior structure and helping maintain proper cooking conditions. Fits the range's lower compartment. What it does:

• Replaces the oven's lower cavity panel to restore a flat, stable cooking surface
• Helps keep heat contained in the lower oven for consistent cooking
• Stops rattling or interference caused by bent or damaged bottom panels
• Addresses visible damage, dents, or warping of the oven floor or cavity

• Disconnect power to the appliance before servicing to avoid shock hazard
• Allow the oven to cool completely; wear gloves to protect hands from sharp edges
• Follow the manufacturer's service manual for disassembly and torque/spec details

This main base is the replacement support housing that secures internal components and helps keep the appliance stable and properly aligned. Installing a new base restores proper support and reduces vibration or misalignment. What it does:

• Provides the structural mounting surface for motors, pumps, and other internal assemblies
• Restores proper appliance alignment and stability to reduce vibration and noise
• Replaces cracked, warped, or damaged base housings that can cause rubbing or misfit
• Helps maintain correct component spacing for reliable operation

• Disconnect power and water before starting any repair
• Basic hand tools are typically required; follow the appliance service manual for disassembly steps
• Inspect adjacent mounting hardware and gaskets; replace if worn or damaged

This burner box is the oven's metal housing that holds and positions the bake/broil burners and channels gas flames for proper heating. Replacing a damaged box restores safe flame direction and consistent oven operation. What it does

• Supports and secures the bake and broil burners inside the oven cavity
• Directs burner flames and helps ensure even heat distribution
• Helps prevent flame impingement on surrounding components
• Commonly replaced for visible corrosion, warping, or blistered metal that affects flame pattern

• One burner box (oven burner housing) as shown

• Turn off and disconnect power and gas supply before starting work
• Follow OEM service manual for removal and reinstallation steps; handle gaskets and mounting screws carefully
• After installation, check for proper burner alignment and test for gas leaks with a soap solution

This burner box is the metal housing that holds a cooktop/oven burner in place and protects internal components from heat and spills. It restores safe burner placement and helps maintain even heating when undamaged. What it does

• Secures the burner assembly and keeps it properly aligned for reliable ignition and flame.
• Shields internal wiring and components from grease, spills and direct heat.
• Helps direct heat away from surrounding parts to prevent damage and hot spots.
• A damaged or corroded box can cause burner misalignment, poor ignition, or uneven cooking.

• Disconnect power and gas before starting any repair.
• Follow the appliance's service manual or wiring diagram for safe removal and reassembly.
• Use basic hand tools; replace any damaged mounting screws or gaskets as needed.