Parts for Ge JEM25WV02: 01 - Section1 Parts

Supports the microwave door hinge assembly for smooth opening and closing. Replace if bracket is bent, cracked, or broken causing door misalignment.

White plastic clip plug for microwave interior. Installs to secure components or cover mounting holes. Order a replacement if original is cracked or missing.

Fix uneven heating in your microwave with this stirrer blade replacement. Distributes microwaves evenly for consistent cooking. Simple 15-minute repair.

Microwave not heating or heating unevenly? A failed magnetron is the likely cause. This high-voltage tube generates microwave energy to cook food.

Microwave not heating or humming loudly? The high-voltage diode converts AC to DC for the magnetron. Repair takes 30-45 minutes with basic tools.

The Microwave Door Switch is an OEM part for GE microwaves, designed to prevent the microwave from operating when the door is open by interrupting the power whenever the door is not securely closed. The door switch is an essential safety feature.

The Microwave Door Switch is an OEM part for GE microwaves, designed to prevent the microwave from operating when the door is open by interrupting the power whenever the door is not securely closed. The door switch is an essential safety feature.

This small replacement cushion pads the oven lamp cover to prevent vibration and keep the glass cover seated securely. It restores a snug fit so the lamp cover doesn't rattle or shift during oven use. What it does:

• Cushions and centers the oven lamp cover to reduce rattling and vibration
• Helps keep the lamp cover properly seated and aligned with the housing
• Protects the lamp glass from direct contact with metal edges
• Can be used if the original cushion is torn, missing, or hardened

• One oven lamp cover cushion

• Disconnect power to the appliance before servicing; allow the oven to cool completely
• Remove the lamp cover and replace the worn or missing cushion, then re-seat the cover
• Handle the lamp glass carefully to avoid breakage; wear gloves and eye protection
• If the cover or lamp assembly is cracked or damaged, replace the damaged components rather than relying solely on the cushion

Mounting bracket for microwave installation. Replaces broken, bent, or missing brackets that secure the microwave to the wall or cabinet during setup.

Ceramic

This wire harness "B" connects electrical circuits inside the appliance to restore reliable power and signal routing. It replaces a damaged or worn harness to help components receive proper electrical connections. What it does

• Provides the factory routing and connector set for the appliance's internal electrical circuits
• Restores power and signal continuity when a broken or shorted harness causes intermittent or no operation
• Prevents loose or exposed wires that can cause arcing or component failure
• Matches OEM connector types to ensure a secure fit with control boards and components

• One replacement wire harness "B"

• Disconnect power before starting any repair to avoid shock or injury
• Compare the new harness to the old one to ensure correct connector types and lengths before installing
• Route and secure the harness using the same clips and fasteners to prevent chafing or pinching
• If wiring or connector damage is observed beyond the harness, inspect adjacent components and wiring; do not attempt unsafe splices

Microwave not heating or making humming noise? The high voltage transformer powers the magnetron. This repair requires electrical expertise.

Small keyed retaining spring that secures and tensions moving components in your microwave. Replaces worn, missing, or broken springs to restore alignment.

Replace your microwave's control panel push button if it's cracked, broken, or missing. This button installs on the control panel for operating settings.