Parts for Bosch B18IW50NSP/06: Molding Parts

This active carbon filter refreshes the air when your range hood is set to recirculate. Replace a saturated filter to restore effective odor reduction and maintain a more comfortable cooking space. What it does:

• Adsorbs cooking odors in recirculating operation
• Helps maintain fresher indoor air when venting back into the room
• Restores odor-removal performance when the old filter is saturated
• Typical signs it's time to replace: persistent cooking smells or diminished odor reduction

• One activated carbon filter

• Disconnect power to the hood before servicing
• Remove the metal grease filter(s) to access the charcoal filter
• Release the old filter from its clips/bayonet mount and install the new filter in the same orientation until it locks
• Charcoal filters are not washable; replace when saturated

• For hoods configured for recirculation; not used when vented to the outdoors

Replacement retaining pin that secures appliance components so panels, hinges or linkages stay connected. Use this direct-fit hardware to restore proper alignment and reduce looseness, rattling or separation caused by a missing, bent or worn pin.

• Secures mating parts like hinges, levers or shafts to prevent separation and play
• Common symptom: loose or rattling door/panel or misaligned assembly where the original pin is missing or damaged
• Typical use: keeps pivot points and small assemblies aligned for proper operation
• Metal fastener designed for a simple, local replacement

• Disconnect power (and water, if appliance type requires) before servicing
• Remove any obstructions and note original orientation before removing the old pin
• Use appropriate hand tools; do not force parts—if fit is tight, inspect mating components for damage

A decorative profile stripe that restores the appliance's finished appearance and covers the cabinet edge. Replaces a worn, cracked, or missing trim piece to improve the look of the unit. What it does

• Provides the exterior trim/edge cover that completes the appliance front
• Hides gaps between panels and creates a smooth, finished appearance
• Commonly replaced when the stripe is cracked, peeled, scratched, or missing
• Helps prevent dirt and moisture from collecting in exposed seams

• One profile stripe decorative trim piece as shown

• Generally installs by snapping or sliding into place; follow your model's service instructions
• Clean mating surfaces and remove adhesive residue before installation for best fit
• Handle carefully to avoid scratching the finish during installation

This fixture is the replacement mounting component used to secure internal parts and assemblies in place, restoring proper alignment and reducing rattles or movement. It's a direct-fit replacement when the original fixture is cracked or missing. What it does

• Secures and supports nearby panels or internal components to maintain correct alignment.
• Prevents rubbing, vibration noise, and misalignment caused by a broken or missing fixture.
• Helps maintain the appliance's intended fit-and-function of adjacent parts.
• Use when visual damage, looseness, or part migration is observed.

• One fixture component

• Turn power off and disconnect the appliance before beginning any repair.
• Access the location via the appropriate panel or assembly; retain screws and fasteners for reassembly.
• Replace only the damaged fixture and verify adjacent parts are not worn.