Parts for Bosch WTMC532CUS/05: Motor Assembly Parts

The Temperature Limiter is an OEM component specifically designed for select Bosch vented dryers requiring controlled airflow temperatures. As a safety device, it restricts exhaust heat to prevent overheating risks.  

Precisely calibrated links of heat-treated alloys automatically trip circuits upon exceeding preset thermal thresholds. Protected housings shield reactive cores from moisture while allowing intended response capabilities.

Causes often involve years of exposure distorting sensitive triggering components slow to cool cycles. Intentional physical manipulation could also disable protection absent automatic overrides.

Symptoms of a bad temperature limiter include:

• Inability to sense and respond to rising exhaust air temperatures  
• Lack of functioning cool-down phases from disabled safety trips
• Continuously energized heating systems without regulation posing risks

This OEM Bosch replacement limiter is also compatible with Thermador, Gaggenau and select Kenmore dryers employing sensitive temperature cutoffs. Correct installation restores critical safety control circuits.
 

The Motor is an OEM component specifically designed for select Bosch electric dryers. Powering the tumbling drum, its precisely balanced construction generates consistent motion. Permanent lubrication withstands thousands of cycles.

Causes of a faulty motor commonly involve winding failure and diminishing torque output. Overheating causes internal damage necessitating replacement before hazards arise.

Symptoms of a bad motor include:

• Slow or incomplete tumbling resulting in damp loads  
• Grinding noises during operation
• Chronic imbalances necessitating resets 

Causes of a bad motor can relate to typical degradation reducing efficiency. Prolonged high-heat exposures weaken insulation requiring timely replacement. 

This OEM Bosch part is also compatible with some Miele and Asko dryers. Replace to retain smooth controlled drying for fluffy fully-ventilated fabrics long-term.
 

This fan wheel circulates air through the appliance to support drying and cooling cycles, restoring proper airflow and temperature regulation. Replaces a worn or damaged blower impeller to improve performance and reduce overheating risk. What it does:

• Spins to draw and push air through the appliance's vent and heating chamber.
• Restores airflow when a cracked or warped wheel causes weak drying or poor ventilation.
• Can reduce unusual rattling or grinding noises caused by broken blades or imbalanced rotation.
• Helps prevent overheating by maintaining designed air movement.

• One fan wheel

• Disconnect power (and gas supply, if applicable) before beginning service.
• Access the blower housing; confirm orientation and fit before final assembly.
• Inspect surrounding seals and fasteners; replace any damaged clips or screws to ensure secure mounting.
• If you hear continued noise or airflow problems after install, re-check wheel clearance and shaft/bearing condition.

This replacement screw secures appliance panels, brackets, and internal components so your unit stays assembled, aligned, and quiet. Replace stripped, missing, or corroded screws to restore a tight fit and help prevent vibration or leaks.

• Fastens panels, trim, brackets, or internal parts in their correct position
• Helps maintain alignment and sealing to reduce noise and potential leaks
• Replaces worn, stripped, rusted, or lost hardware
• Common symptoms: loose or rattling panel/handle, misaligned parts, components shifting

• Disconnect power and, if applicable, shut off water before servicing
• Match the head/size to the original hardware; do not mix lengths across locations
• Start threads by hand to avoid cross-threading; tighten snugly without over-torque
• For plastic or thin sheet metal, avoid overtightening to prevent stripping or cracking