Parts for Ge DCCH485EK0MS: 05 - Motor & Blower Assembly Parts

This part is a genuine OEM condenser assembly made for use with dryers. The condenser moves hot air to the condensing chamber to condense it into water, which is then collected underneath the appliance. Over time, the condenser may become faulty, which will prevent it from working properly. The user may start to notice clothes are still damp, even after a full cycle. In this case, the condenser should be immediately replaced. Make sure to unplug the dryer from the outlet to prevent serious injuries when undergoing the replacement process.This part is manufactured by General Electric and has been sourced directly from the manufacturer. It is sold individually. It is an authentic replacement part and thus is compatible with dryers manufactured by General Electric, Hotpoint, and RCA.

This is a replacement M6.5 × 25 mm machine screw used to secure panels and components on compatible appliances. It restores proper fastening where a missing or damaged screw causes loose parts or poor alignment. What it does:

• Secures panels, brackets, or assemblies that use an M6.5 × 25 mm fastener
• Stops rattling or vibration caused by a missing or stripped screw
• Restores proper component alignment for doors, panels, or internal mounts
• Matches OEM thread size and length for a direct-fit replacement when specified

• Disconnect power and, if applicable, water before servicing the appliance
• Use the correct driver or socket to avoid stripping the head
• Start threads by hand to prevent cross-threading; tighten until snug—do not over-torque
• If the original mounting hole or threads are damaged, repair or replace the mating part before installing

This blower wheel nut secures the dryer blower wheel to the motor shaft, keeping the wheel stable for proper airflow and drying. A simple replacement that stops wobble and helps restore quieter, more efficient operation. What it does:

• Holds the blower wheel firmly on the motor shaft to prevent slipping or wobbling
• Prevents noise caused by a loose blower wheel
• Helps maintain consistent drum airflow for better drying performance
• Reduces wear on the blower assembly by keeping parts aligned

• Disconnect power before starting any repair to avoid shock or injury
• Access may require removing the dryer front panel or blower housing depending on model
• Typically removed/installed with a socket or pliers; hold the blower wheel to prevent spinning while tightening
• Tighten securely but avoid over-torquing to prevent thread damage

This replacement leveling leg threads into the base of your appliance to support and stabilize it. Adjusting the leg lets you level the unit on uneven floors, helping cut vibration, movement, and rattling during operation.

• Threads into the base to support and level the unit
• Adjusts height to correct rocking or wobble
• Helps reduce vibration, walking, and rattling noises
• Useful when a leg is missing, bent, or the foot pad is worn

• Disconnect power; for gas models, also shut off the gas supply
• With a helper, carefully tip the unit to access the legs
• Unscrew the worn or damaged leg; thread the new leg in by hand to avoid cross-threading, then snug as needed
• Adjust all legs and verify the cabinet is level front-to-back and side-to-side with a bubble level

This replacement switch cover protects and secures the appliance's control switch assembly, restoring a finished appearance and reliable button support. Designed to fit the OEM switch housing for safe, stable operation. What it does:

• Covers and protects the control switch area from dirt, moisture and wear
• Keeps switches properly seated so buttons press and release correctly
• Restores a snug, finished look to a damaged or missing control area
• Helps prevent accidental switch damage from bumps or debris

• Disconnect power to the appliance before starting any work
• Remove the control panel or bezel as required to access the switch cover
• Reuse existing fasteners unless the replacement explicitly includes new hardware