Parts for Ge AZ28E09DACM2: 02 - Motor & Chassis Parts

Rubber cushion that mounts between the air conditioner motor and chassis to reduce vibration. Replace if cracked, hardened, or missing.

Secures and shields the condenser assembly in room air conditioners. Replace if your original plate is cracked, damaged, or missing to restore stability.

Rubber washer for air conditioner unit assembly. Installs between components to create seal and reduce vibration. Replace if cracked, worn, or missing.

This D filter is the dryer lint screen that traps lint and debris from the drying drum, helping maintain proper airflow and reduce lint build-up for more efficient drying. Fits dryers that use a D-shaped lint screen. What it does:

• Captures lint, fibers and small debris to prevent them from re-entering the drum or vent
• Helps maintain airflow to avoid longer dry times and poor drying performance
• Reduces lint buildup that can contribute to overheating or vent blockages
• Works as the removable screen you clean between cycles to keep the dryer running efficiently

• One D filter

• Disconnect power before inspecting or replacing the lint screen
• Remove the old screen by pulling it out of the housing, clean the housing, then insert the replacement until it seats fully
• Clean the screen after each load; replace if cracked, warped or damaged
• If dryer still shows poor airflow after replacement, inspect the venting system for blockages or damage

Replacement mounting nut for air conditioner units. Secures panels and components during installation. Needed when original nut is stripped, lost, or damaged.

Special mounting screw for air conditioner assembly. Replace if screw is stripped, missing, or damaged during maintenance or installation work.

Special screw for air conditioner assembly. Replaces lost, stripped, or damaged screws during installation or repair. Secures components properly.