Parts for Frigidaire DWU2005DR2: 07 - Motor Pump Parts

Dissolves limescale, mineral deposits, and odor-causing residues from dishwasher tub and spray system. Use monthly to maintain peak cleaning performance.

This retainer lever secures and positions a moving component inside the appliance so doors, trays, or assemblies operate correctly. Replacing a worn or broken lever restores proper engagement and prevents loose or misaligned parts. What it does:

• Holds and guides a mating part or linkage in place to ensure consistent engagement
• Prevents assemblies from slipping or coming out of position during use
• Helps restore normal opening/closing or indexing behavior when the original lever is cracked or broken
• Works as a direct-fit replacement where the factory lever has failed

• One retainer lever

• Install with power disconnected and any moving assemblies supported or restrained
• Inspect adjacent clips, pins, or fasteners and replace if damaged—only the listed lever ships
• Use basic hand tools; avoid forcing components—ensure correct alignment before fastening

Dissolves limescale, mineral deposits, and odor-causing residues from dishwasher tub and spray system. Use monthly to maintain peak cleaning performance.

This O-ring is a small rubber seal that restores a watertight connection at a plumbing or valve joint, helping stop drips and leaks and keep your appliance operating normally. What it does:

• Provides a flexible, compressible seal between two mating parts to prevent water leaks
• Commonly used on valve fittings, hose connections, and dispenser plumbing
• Symptoms a failing O-ring can cause: visible dripping, pooled water, or intermittent water flow
• Small, low-cost part that often resolves minor leaks when the correct size is used

• Turn off water supply (and power if applicable) before replacing the O-ring
• Remove the old O-ring and inspect mating surfaces for damage or debris; clean before installing the new ring
• Do not reuse a deformed or torn O-ring; install the correct size and seat it evenly
• After installation, restore water and check the connection for leaks; tighten fittings only as needed to avoid crushing the O-ring

This side mounting bracket kit includes the hardware needed to secure a dishwasher to the adjacent cabinetry from the sides rather than from the countertop. It is commonly used in kitchens with granite, stone, or other countertops where top-mounting screws cannot be used. Replace this kit if the original brackets are bent, broken, or missing, causing the dishwasher to shift or slide during operation.

Dissolves limescale, mineral deposits, and odor-causing residues from dishwasher tub and spray system. Use monthly to maintain peak cleaning performance.