Mtd Gold Engine Parts

External gasket kit seals carburetor and engine surfaces on lawn equipment. Replace when you notice fuel leaks or loss of compression. Verify fit with your model.

Replace your engine's oil fill plug if it's cracked, stripped, or missing. This plug seals the oil fill opening on small engines for snowblowers and tillers.

Ignition coil for small engines on lawn and garden equipment. Replace if cracked, damaged, or worn. Includes spark plug boot and wire assembly.

Fixes snow thrower that won't start or has a broken pull cord. This recoil starter assembly restores manual starting function. Moderate DIY repair.

Oil fill plug assembly for small engines. Seals the oil fill opening to prevent leaks. Replace if cracked, stripped, or missing to maintain proper seal.

Starter rope won't retract after pulling? This recoil pulley and spring assembly fixes rope retraction issues on mowers and small engines. Direct fit.

Carburetor gasket for walk-behind mowers. Replace when you notice fuel leaks, hard starting, or during carburetor service. Verify fit with your model.

Plastic primer bulb that draws fuel into the carburetor when pressed. Replace if cracked, broken, or no longer creating proper seal for priming.

Governor spring for snow thrower engines. Replaces worn, stretched, or missing springs that control engine speed regulation. Direct fit component.

Fuel cap for gas-powered engines and outdoor power equipment. Seals fuel tank to prevent debris, dirt, and air contamination. Replace if cracked or loose.

This is a recoil starter assembly for lawn and garden power equipment. When the recoil starter rope is pulled, this causes the spark which starts the engine.A new recoil starter assembly will be needed if the recoil or pulley system has broken. The rope may become broken or frayed and the plastic on the pulley could crack. If the rope becomes loose and there is no tension when it is pulled, then a new recoil starter assembly will be needed.This part is a genuine MTD part and is an OEM part sourced directly from the manufacturer and it is sold individually. It is used on engines, lawnmowers, lawn tractors, and log splitters that are manufactured by MTD, Yard-Man, Yard Machines, Cub Cadet, Husky, and Troy-Bilt.

Carburetor assembly for snow thrower engines. Installs on the engine block to mix air and fuel. Replace if cracked, damaged, or leaking fuel.

Bell washer for lawn mowers and tractors. Installs to secure components and prevent loosening. Replace if cracked, worn, or missing for proper assembly.

Replace a cracked or broken ignition coil on your walk-behind lawn mower. This part sends power to the spark plug and may need replacement if damaged.